[Nova5]

Almost there! I just have to wait on the paint to dry on the drivers side back plate, cut the shroud for it, shave down the friction ring and put on the cover!

Passenger side is assembled and road worthy! I will need to devise a gasket or rain shield to bridge between the hood and front cover. Since this car has had a front end impact its not quite perfect.

Here she is!



The shroud is held on by a friction ring made from a 3" sewer (3034) pipe female adapter. Cut the slip fit side off at the right size to fit in the exhaust tip shroud, I did have to take a section of the ring out so its a open loop. Used a sanding drum on the dremel to thin it up enough for the shroud to slide on with a bit of a push.