02 z28 vs mach 1?
TECH Apprentice
Joined: Aug 2006
Posts: 335
Likes: 0
From: CA
basically. IMO, giving actual feedback in this threads being in the wrong section is no worse than starting the threads. But, that's just me.
10 Second Club
Joined: May 2009
Posts: 3,427
Likes: 227
From: over dere
Teching In
Joined: Oct 2005
Posts: 46
Likes: 0
10 Second Club
Joined: May 2009
Posts: 3,427
Likes: 227
From: over dere
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Launching!
Joined: Jun 2008
Posts: 218
Likes: 13
don't be so dilusional...just for one example...dude over on svtperformance trapped 107 in his mach with only midpipe/catback (same as what stopsign mentioned)...you don't think 107 is enough to take out your average ls1 from a roll? whatever you think 
Launching!
Joined: Apr 2008
Posts: 289
Likes: 0
My friend is trying to set me up to race a mach1 a friend of his has. As far as i know all he has is a CAI and its a manual. The kid is still in school and mommy and daddy bought it for him. And highly doubt he's a good driver. Just wanted to get some opinions on what the outcome should be.
That's me racing a new guy on our local forum last week. He has catback exhaust and a cold air intake. In the far lane is a terminator making 445rwhp....pause the vid at 16 seconds....
Last edited by squale iii; Nov 7, 2009 at 08:38 PM.
10 Second Club
Joined: May 2009
Posts: 3,427
Likes: 227
From: over dere
and you think 107 is an average trap for a mach like that? get real.
10 Second Club
Joined: May 2009
Posts: 3,427
Likes: 227
From: over dere
Launching!
Joined: Jun 2008
Posts: 218
Likes: 13
Oh and that run I did a 13.2. Nothing amazing and people have done better but that is right there with your average LS1 time... Just saying.
10 Second Club
Joined: May 2009
Posts: 3,427
Likes: 227
From: over dere
The Mach 1 I'm talking about ran 105.8mph with nothing but a catback. That was with me driving, never driven a Mach 1 on the track, and I was only able to get that one run in. Had I gotten a few more runs to get to know the car better I would have done quite a bit better I'm sure. I'm not the best driver in the world but I have figured out which pedal does what.
Oh and that run I did a 13.2. Nothing amazing and people have done better but that is right there with your average LS1 time... Just saying.
Oh and that run I did a 13.2. Nothing amazing and people have done better but that is right there with your average LS1 time... Just saying.
it's a manual... my buddy also has a full bolt on 96 cobra with 4:10's you could use too.. his cousin has a stock m5 mach.. take your pick. best out of 3 loser buys beer.
a 13.2 is very quick for a mach. it happens, but rarely. alot run more in the 13.5-13.6 range around 104-ish. why do you think when you look at videos of races between the two 9 times out of ten the ls1 wins--- because it's faster! sure the mach CAN win but chances are it wont. but it's close enough that if the ls1 driver ***** up he wont run it down by the end of the quarter.
I didn't think your car was stock though so how would this be fair? (edit I see you said close to stock)Where do you live?