Current Set-up
1. Edelbrock slip-fit drag headers
2. Custom set-up, 12" Dynomax Bullets with pipes ending up each door
3. N/A
4. No cats
5. No tuning so far
6. No dyno results either but at the track I dropped 4 tenths off my ET in 1/8
7. The install wasn't that bad, only took me a couple of hours. There is a little bit of rubbing on the K-member but not too bad. After all the work, I am very pleased with my setup.
8. I would recommend anything that I have done to anybody. |