[ssduane]

I'll try to post up some pictures later. Most of the eng/trans wiring is done, just need to adapt it to the cars wiring, which is getting redoen at the same time (painless 18 curcuit harness). My stock driveshaft I cut down to install. Doesn't quit fit but will allow the driveshaft to stay in to "chock" it in the garage/driveway. I have a 1350 yoke on the 9", so stock doesn't quite fit. Rear brake lines are being ran, will do rear to front this week hopefully.

Starting to think of another color scheme. Decisions decisions.