- aftermarket shifter ball
- 60 ft. times Track Guys??
- clutch master cylinder dosnt engage all the way
- No Clutch Pressure!
- New clutch problems! PLEASE HELP!!
- reverse lockout problem
- No Spacer behib Slave Cylinder?????
- Exo-skel v/s Street twin with drag radials
- Any one ever rebuild a mcloud adj m/c
- 4l60e to t56 help
- Is this Transmission Backlash normal?
- Used Spec 3?
- shifter removal help
- LS2 vs LS1 Pilot Bearing
- Factory Hurst and WS6 Store SS
- T56 Rebuild: local or T56rebuilds.com
- Slipping
- What Shifter should I get
- Looking for a clutch setup
- Push clutch to start car question????
- '01-'02 Slave cylinders.
- Specific differences between F-Body and GTO T56?
- new shifter install...
- shifter problem
- Anyone wanna trade their M6 for a built A4
- SPEC5 Clutch issues
- 10's with stock T56?
- slave cylinder ?????
- Think my trans got hurt when rearend blew
- hurst comp plus / hurst billet plus
- a4 to m6 who made the switch?
- part numbers?
- Rebuilding my T-56, Replacing a few things. Need advice.
- LS7 clutch in C6 problems
- Need New T56 & clutch help!!!
- Hurst billet plus = WOW
- Questions for an A4 to M6 swap
- Corvette manual question...
- Can we use the new viper Tremec TR6060 trans????
- Clutch change, what pieces and parts do i need.
- HIGH SPEED VIBRATION, help
- Corvette Knob
- ordering a clutch by this weekend, please help me.
- Top transmission bolts and wiring
- cant downshift from 6th to 5th
- Tailshaft housing for t56
- ANyone running a adjustable master and LS7?
- who sells prebleed master/slave assembly
- ls7 clutch limits
- LS7 advice???
- T56 Guru's, In Here, Please...
- Gotta Love the T56
- Spec Clutch Disk
- Which is best? Pro 5.0, Hurst Billet+ or B&M...
- LS7 Clutch Kits In Stock - SALE!
- Clutch went "pop", lost pedal and smoke in the vents...???
- No reverse????
- t56 rebuild kits
- use of oil in pilot bearing installation?
- Clutch sticking
- I've had it with my Textralia Oz700...
- Textrailia Exo Skel installed
- T56 in 6.0 Iron Block?
- Did the 94 T/A have a FIVE SPEED ?????
- how much tranny fluid do i need?
- Spec 1 or 0Z700?
- Vss
- Jammed gear??
- Gen 1 smallblock to T56
- Clutch tightness
- T56 Input Shaft Wont Line Up?
- ebay shifter
- Just installed the MN12 into my T/A
- using Lt1 t-56 behind Ls1
- whatever happened to the ebay cluth test?
- Best Budget Clutch?
- Popping out of 4th gear, 2nd as well I think; really cold out.
- stuck in 3rd gear
- how can i take off the hydraulic hose from the master cylinder to the slave??
- drill mod & bleeding not going so well
- lt1 t56 vs. ls1 t56
- Can anyone help me with a part number for the plastic trim for shift boot?
- Installed my short stick. GET ONE!
- Billet flywheels
- loss of power????
- Pressure Plate Bolts?
- ran car aggressively. high rpms, hard going into gears
- short shifter giving faster 1/4's??
- resurface flywheel?
- T56 rebuilds is the best of the best
- So, did anyone call Tremec yet
- Ram HDX clutch. Anybody have? Opinions?
- Grinding in upper RPM's
- Won't go into 3rd, pops out of 1st
- throwout bearing rattle
- Quick Bellhousing Question
- Swap 04 GTO T-56 into 98 Z28 w/ T-56???
- m6 or a4 for turbo DD
- New Master Cylinder?
- Sticky clutch pedal
- ls7 VS spec3+ and other questions
- How much can I sell my T-56 for????
- 2001 z06 want to put auto in how hard?
- Update on T-56 issue
- input shaft broke
- Clutch goboom!
- Syncros Or Other Problem?
- Car Wont Go Into Gear!!!!
- Car won't Go into Gear
- trans/clutch stuff for 3.4 to LS1 + T56 swap
- Car stuck in N and will not shift after started
- T56 in a 70 gto
- shifter knob
- Spec Stage 4 users inside please
- what gear ?
- LS7 Clutch + Aluminum Flywheel (Who has it??)
- part # for 1le mount? thought i had it but...
- drill mod for clutch master
- What's the difference?
- Question about my friends 2000 GT
- Pressure plate bolts, flywheel??
- Clutch Sticks but not if Pumped
- How to test for loose Flywheel??
- Help me choose a clutch plz
- Who has blown up a clutch in their LS1 F-body?
- Where to buy braided line for drill mod
- Ordered....
- another t56 bites the dust
- *which Clutch?
- Recomemd Clutch / Flywheel
- just got the RAM Powergrip HD installed...
- Downshift and boom
- Can I replace flywheel without replacing clutch?
- HAY-85-105 Clutch ??
- Annoying sounds after clutch install.
- 6 speed conversion?
- Proshifted tranny?
- t56 question
- Gear vs Speed calculator (macro and non-macro)
- annoying problem with trans.
- Best clutch for 600ft/lbs
- Trans mount
- 3rd clutch gone - whats the deal?
- Which rear gear ratio with a T56 in a 408 Stroker???
- LS7 Experience; Good or Bad?
- Textralia OZ700 vs ExoSkel...Opinons?
- T-56 Transmission Problems
- Questions for guys who rebuilt their own T56
- T56 from LT1 into ls1 Posssible?
- Is there a trick to removing M6 shift knob?
- Exoskell clutch specs
- Please help! Clutch problems
- hurst shifters
- EXO-Skell / Spec Stg 3 Review
- ls2 flywheel resurfaced, problems finding shim!!! please help
- where should i get my trans redone at?
- Here are weights of LS7 clutch, aluminum flywheel vs stock
- Bronze fork pads for 5 - 6?
- Which Z06 Clutch for an '00 SS?
- wtf is wrong with my tranny
- Braided Line (Drill Mod)
- My t-56 is toast
- new clutch problems
- How Much Should Ask For My Tranny
- Need Help on Part numbers for LS7 Clutch
- m6 mated to a 5.3
- Spacer between 5th gear bearing and 5/6 synchro snap ring
- Clutch only engages when cooled off...
- please help!
- Clutch sticking to the floor.
- tranny noise
- Help and opinions please! Hydraulics???
- slp short throw shifter
- Reverse synchronizer retaining ring?
- What happened to my T56
- Textrailia review(30 miles). M6 question. This clutch is cool!
- hole in cap of clutch fluid lid?
- yet another synchro ?
- Can you add "Friction Material" to a Flywheel?
- Clutch difficulties
- nasty squeaking noise. help!
- HELP with thread size for slave and shifter
- clutch not disengauging?
- Problem with clutch
- do i need new pads or synchros?
- What fly wheel?
- rebuild question, what comes off next?
- Tranny problems..
- B&M short stick shift knob removal?
- T56 problems when WOT shifting
- After considering an LS7 clutch, im reconsidering going back w/ a Spec
- Lowest price for Mcleod LS1 bellhousing??
- fastest m6 list
- T56Rebuilds.com website temporarily down
- slow high rpm shifts
- Do i need a new clutch now or wait?
- getting a m6
- Pro 5.0 webiste?
- How to tell the diff. in 5-6 and reverse synchro?
- Slave/Master cylinder ???
- is the ls7 clutch good?
- Weak slave??
- LT-1 t56 with LS1 Slave??
- LS7 Clutch Pressure Plate Adjustment?
- going on my 3rd pilot bearing...why????
- Problems with Spec 3+
- Help with Raptor install
- Clutch help.
- removing the transmission
- shifters?
- Z06 clutch good enough?
- Pressure Plate "fingers" bent in
- Pro 5.0 shifter stick vs WS6 store short stick
- Clutch LS7 NOT Working
- downshifting problem
- Tools for T56 rebuild. Please check.
- Textrailia
- B&M Ripper vs Pro 5.0
- 103,xxx miles and shot upshift solenoids...time for a rebuild?
- 02 Ta wont go into gear
- opinions on my tranny, pics inside
- signs of dying hydraulics?
- Let me see your shifter knobs!!!
- pistol grip handle
- Exoskell users, give me feedback.
- Clutch or Tranny Help....?????
- Blocking Ring Function
- drill nod questions
- What clutch will I need for these mods?
- trans swap question!!
- please help with m6 conversion
- Cant Remove pilot bearing
- M6 brands
- can I reuse my tranny fluid
- Please Confirm Cartek Fluid DOT 5 or DOT 5.1
- paddle shifters
- Slider still worth using?
- Parasitic HP loss from a dual disk clutch or T56rebuilds tranny???
- Slave Cylinder
- So what's the going consensus on ClutchMasters?
- is my clutch dead???
- Any one ever warp an Aluminum Flywheel?
- RPS Carbon Kevkar Or Spec Stage 3+
- need help finding what clutch i need/flywheel..how to know?
- shifting/clutch problems
- Wont go in gear, hard to shift. HELP!
- will a Lt1 T56 bolt right up to a SBC
- Newb Question
- Okay so you guys hate spec and the LS7 is still a question
- Pilot Bearing Tool: Kent-Moore J-43276