- Will Textralia hold 850 rwhp/750 rwtq ??
- Broken transmission?
- clutch sticking when its cold
- lou's short stick vs. ws6store
- pro 5.0 or hurst billet
- Rebuilding a T-56
- a4-t56 swap..few pre questions
- LS7 clutch install ?
- Searched............is there a write up somewhere on replaceing the tailshaft seal???
- Any good instructions for 1-2 and 3-4 assy?
- Transmission Work (Clutch Sticking) -Orlando
- noob clutch ??
- Where to Buy?
- T handle hurst knob w/short stick
- Noob here...slider?
- t5 trans rebuild- please help me
- im trying to identify this piece
- Rattle
- SPEC 3 and 4, how many pucks?
- viper internals in GM t56?
- Master cylinder braided line
- Which Flywheel???
- Broken tranny mount
- 05 GTO A4 to M6 Swap?
- Speedometer not working after clutch install
- Slight grinding going into gear, what is it?
- ls7 clutch with lightened fly
- stock clutch with 400 rwhp and a 12 bolt?? how long till it pops
- Mikronite Face Plated T-56
- Master braided line.
- Help me choose a clutch for my RWHP.
- Need T-56 main shaft
- Hard To Get Into 5th Gear
- Shims and bleeding
- Anyone toasted a LS7 clutch?
- Need DD clutch for 500whp on N2O
- Switched from A4 -> M6
- Drill Mod Help????
- Poll: Stock Master or Adjustable
- Master cylinders with Textralia...whats the difference?
- cant find noise location
- Clutch Kill Switch... Will a stock T56 take it??
- Problem with shifting. either clutch or slave cylinder.
- t 56 problems
- short stick on non hurst shifter
- Change Shifter or Stick?
- Sticking clutch pedal
- Cutting Pro 5.0 stick?
- I NEED HELP PLEASE...clutch problems
- How much damage can i do?
- t56 for ls1!!!
- 96 trans am 6 speed
- ticking noise...
- rear gears and T56
- can i put a LT1 t56 onto a LS1 engine?
- Textralia OZ700 install problem
- How long would you expect a Spec 3+ to last in a DD?
- Pro 5.0 on Viper Trans.
- pro 5.0 for ls1 fit lt1?
- switching to GM synchromesh
- Clutch decision
- Bolt pattern questions
- Vibration/rattle under load on accel, any ideas?
- Exo-Skel break in.
- where to get ls7
- clutch question
- Teaching the girlfriend to drive a stick...
- need a new clucth
- Lighten the stock fly wheel?
- LS7 with 400rwhp + 150 shot, think it will hold for long?
- ls7 flywheel?
- Anyone use the LS7 clutch, flywheel, pp?
- POLL. ls6, Centerforce DF, or RAM HDX
- ls6, Centerforce DF, or RAM HDX
- OEM GM or Aftermarket
- McLeod Adustable Master Cylinder
- Differences between LT1 T-56 and LS1 T-56?
- Exo skel
- Tranny Swap..Auto for a Manual...
- Transfer case on a t56 ?
- Fidanza Clutch???
- What is the Strongest Trans....
- Help 3rd gear pops out!
- does my ws6 have a revlimiter?
- At what point is a viper output shaft a good idea?
- chatter and some other noise!!
- 2002 Master cylinder in a 99 z28????
- T56Rebuilds.com GMHTP Rebuild Article
- centerforce
- Master Cylender Rebuild
- help!!!!! i cant bleed clutch!!
- Aluminum Flywheel for LS7 clutch??
- clutch engagement is getting worse...
- Spec Stg 5 :(
- LS2 Flywheel Part Number
- need some help with the shift
- Felt weird "pop", now clutch doesn't work.
- Noise under center console/shifter
- bleeder valve
- Pro 5.0 and WS6 store 6" stick
- Where does this eliminator plug for the skip shift go
- Ram HD & adj. master cylinder???
- what system is best
- Shim For Spec Clutch
- How much is a T56 worth?????
- clutch replacement under warranty????
- fixed my issue
- ram clutch with cyn-r-gy flywheel help
- Slave cylinder?
- Adjusting McLeod MC problem
- t56 cable clutch
- Parts list/choices
- Weird noise!!
- crosshatched flywheel
- Clutch pedal play after getting on it...
- Does the Mcleod Twin disk require a spacer?
- T56 going bye bye
- Ram .150" Shim?
- Weird Noises...
- Will viper tranny work?
- Cant get car into reverse
- Is this any good??? Clutch (PICS INSIDE)
- Sliping out of 3rd gear when engaging...
- Pics of Tex OZ700
- problem shifting
- please help....clutch/slave problem
- crazy low engagement....
- bad shift fork
- Ram Adjustable MC with Textralia clutches?
- Finished rebuilding my T56!
- lowest price clutch kit
- clutch install
- Master Cylinder Question???
- 500hp gto, what clutch should I get?
- TEXtralia OZ700 Questions
- Which clutch for my set-up?
- Stage 1 Spec
- Locking knob in place, turn wise
- How to remove cags disable
- 350 turbo with pilot spacer
- ls7 clutch
- Short stick and knob woes...
- clutch slipping again
- Aftermarket Slave/Master Cylinder?
- clutch issues
- WS6 store Short Stick?
- LS7 Master Cylendar Question
- Anybody use this clutch?
- Cf/ram/mcleod St/tex??
- My T56 Conversion
- Two questions about master cylinder?
- Beefed up T56
- SSR t56 swap
- Slave clyinder??
- 3rd to 2nd problems
- SOMEONE LOOK QUICK :).. Im bleeding my new master cylinder, and its taking FOREVER
- Secret to pulling the 3/4 synchro hub?
- clutch for 800rwhp/800rwtq
- trans problems with only 42,000 miles
- Shifter Boot Part Number
- High Hp/Tq T56 questions
- Shifter Boot Support
- T56 Rebuild guide
- Clutch change questions
- McLeod Master Cylinder Bad AGAIN!
- TCS OFF eliminator
- What do I need for clutch replacement?
- Clutch/Flywheel Advice
- Auto to Manual swap...few q's
- Help Opened front cover Tranny came out of Alinment
- THANKS T56 Rebuilds
- SPEC: Boo stage 2
- spec 3 problems
- polyeurathane tranny mounts
- 99 s10 ls1 6 speed
- clutch chatter driving my brother nuts!
- Exo-skel Torque specs needed!
- Pro 5.0 shifter knob thread size
- This does NOT look good
- auto to stick...
- a cheap way for LS1 T56
- T56 c5 gearbox into a f body housing
- 6-Speed pattern on top - Leather knob for an F-body?
- OZ 700 PP bolts?
- Anyone running a Jerico trans?
- 1LE Transmission Mount Availability
- slave replaced but pedal stuck still
- cant downshift to 4th without grinding
- rev motor = spongy pedal
- is my throwout bearing trashed ?
- no speedometer or odometer
- rps clutch problem
- Selling My M6
- Why red thread locker?
- Anyone's Master Cylinder squeak
- ls7 clutch & fidanza flywheel
- Textralia clutch after 1500 miles and 15+ dumps
- 1/2 shift fork aluminum?
- Help me pick a new clutch
- Twin disc clutch question
- t-56 shifter to a t-5
- Those who have torn down their own tranny...
- what could this be??? pressure plate or clutch
- i cant figure out what it is...
- LS7 Clutch Trouble
- T56 Advice needed.
- Is there a trick to getting the tranny to slip back in.
- What a day (clutch woes)
- is it a clutch problem, or a tranny problem?
- Fidanza short throw install
- trans temp gauge?
- Positive note for Spec 3+
- no psi after drill mod??
- Need your help....
- t56 removed. question
- Diameter pipe for 5/6 gear install?
- reverse lockout question
- What Clutch????
- Mainshaft Bearing Issues
- best place to get a fill plug for the t56?
- tranny jack need to remove t-56
- I Have a Question and Need Advise Fast
- Help. Clutch won't disengage.
- Torque arm Bushing
- transmission removal
- Spec flywheel
- Pro shifter installed w/white hurst ball
- bell housing wont come off!!!
- Slave Cylinders
- Project Crazy Power is ALIVE!!!!!!!!!!!!!!!!!!!!! 1st DYNO NUMBER IS IN
- Knocking sound near bellhousing
- Trans issues...advice needed
- napa clutch?
- Ok to drive with worn synchro?
- Ebay clutch kit? Good? Bad?
- cluch on 03 Z06
- Where can i get LS7 clutch?
- exo skel question
- Anyone using the RAM Adjustable master cylender?
- What clutch/flywheel should I get?
- LS2- LS7 clutch??
- how long did you manual trans last?
- and.......The TA breaks down.
- What shifter is this?
- Viper Tranny for GM/conversion
- Help!!
- Swapping to the t-56 today
- clutch problems
- clutch fluid question
- which side Pilot Bearing?