- brand of atf for t56?
- No Fifth or reverse
- Textralia clutch users. In here.
- HELP!?!?!? I need to fine a hydralic line??
- 480whp z06 H/C setup - need DTE brace with "bullet proof" tranny?
- Dood im pissed.. anyone have this problem??
- AH my transmission went out
- Shifter question.
- Quite possibly the stupidest question ever
- Question
- Grinding Noise when i let clutch out!!!
- Can't put into gear
- Need Help Quick!!! Clutch install
- Clutch vibrations go away with break-in?
- Driveshaft length with M6 and 9" needed Please
- Ws6 Stores Short Stick,What You All Think?
- z06 tranny in an f-bod?
- Heli-coiling Aluminum flywheel ?!?!?!?
- Clutch differences between 97 & 02
- can i race with clutch sticking problem
- Shimming a Textralia
- chatter after spec stage 3 install
- Pedal Play
- is there a plate between the block/trans?
- B&M RIPPER NOISE!!
- Which of these clutch sets would you guys pick?
- new clutch
- Clutch travel after drill Mod
- Anyone ever fix the clutch stuck problem?
- did i get screwed or am i confused??
- Mc Cloud Adj. Master
- Clutch woes...Need some help
- Another ls7 clutch post (flywheel?)
- Good budget clutch?
- ls7 clutch and ls2 flywheel
- Where to get an input shaft?
- Need a clutch
- Clutch Pedal Spring....Where to Buy?
- grinding with my t-5
- what tranny???
- Clutch Problem?
- Clutch questions...air in Master or possibly flywheel bolts backing off? (Kinda long)
- T56 Shifter option !!
- Mcleod twin disc/built t56
- What are some tips for long clutch life?
- please answer this diffecult question!
- clutch, flywheel, pressure plate procedure/hours
- T56 Rebuild
- clutch Replacement
- More Pre-Clutch Install Questions
- Which clutch
- some thing broke on my master..
- LS7 Clutch Flywheel Recall
- strange noise from under car???
- Which harness goes to the Reverse Solenoid
- Differences in Slave Cyl
- Drill mod
- Clutch "break in" question
- Hurst Billet Plus shifter question...
- Clutch problem
- M6 Driving tips
- Shift lights?
- LS7 Clutch Info
- help with spec to shim or not to shim?
- What clutch do I have?
- Anyone spraying on a Ram HD?
- New McLeod clutch is sweet!
- Dropped socket in bellhousing bleeding clutch
- torque spec on bellhousing bolts
- B&M Ripper
- What should I do?
- New Clutch
- Clutch sticks to the floor once hot
- Time to flush. Recommendations on fluid please.
- Explain the problems with t56 trans?
- Help, Clutch Install
- clutch issues
- a bit worried
- my 6-speed
- Need a new clutch soon.....help!
- C5 FRC stock clutch limits
- HELP! Bellhousing stuck to motor! How do I remove?
- T56
- Ebay shifter
- Shift boot and console top for A4 to M6 swap
- 97 brakes on a 98 ss
- SPEC 3 help please...Have a few questions....
- This F@#$ing Sucks
- Poly tranny mount, won't bolt up
- Diagnose this problem
- HELP! How do I know if my motor/tranny mounts r shot!?
- Clutch and rear end problems... PLEASE HELP!!!
- LT1 t56 rattle TO bearing?
- Spec Stage 1 clutch + Stock Flywheel?
- Push or Pull Clutch?
- i wanna change my shifter knob out
- Power Bleeder
- Who makes a good built t-56?
- LS7 clutch limitations
- Ls1 stock clutch info
- can move out of gear w/o clutch
- Is a Spec Stage 3 clutch going to tear up my M6?
- Shift delay with new clutch
- 2000 Camaro messed up after wreck...
- clutch fluid flush
- trouble to reverse
- Cheapest place to buy Slave cylinder
- *Update RAM HD installed*
- Lowest cruise speed for 6th gear
- Balance the ls7 clutch/pp and ls2 flywheel ?
- Shift Selector Assembly/Rail Pics
- to bearing
- Bellhousing Question
- Shift Boot Retainer Ring
- Clutch chatter when clutch is out and in neutral?
- How have you shipped transmission?
- vibration at 3000 rpm
- LS6 Clutch Reviews
- t56rebuilds
- Components to a WELL built T56?
- Clutch master cylinder same for C5?
- slp shift knob removal
- Anyone use the SLP short shifter?
- How much money does a ......
- get good lauch with my m6 is hard
- Pre clutch install q's.
- Found something interesting while rebuilding
- ARP clutch and flywheel bolts..
- New Flywheel WS6 OLD FLYWHEEL IS TOTALED!!
- How many are running the ls7 clutch right now??
- notchy shifting?
- Clutch pedal problem?
- Should I replace the slave cylinder
- shifter choices
- Tranny build and shifter choice
- flywheel bolts?
- clutch diameter
- Noise@2800+ rpm ????
- Shifter or Springs?
- Am I shifting wrong? WOT technique
- Squeak while textralia clutch is engaging
- 2001 slave cylinder?
- Part number for Pilot Bushing??.. not Bearing.
- Slave problems
- Code P0704 Clutch Switch Circuit
- Torque Management ?
- Can I get opinions on this...
- ALUMINUM FLYWHEEL Is it worth it?
- Whats the Diffrences between an alluminum and billet flywheel
- Time for a new clutch...is the ls7 the best way to go?
- Fluid to run in a m6
- Tranny Upgrade and Shifter Choice
- heres a good on for you guru's Please Help S.O.S.
- LS6 or LS7 clutch
- Carbon Fiber Driveshaft
- Strange clutch pedal feel after slave swap
- Transmission leak, Rear Seal Swap?
- Got my engine as a goodie bag, what clutch is this?
- SS shifter
- Custom Hurst Shifter Handle
- hydraulic ????
- Jumped out of gear...
- Clutch not releasing
- Anyone wanna trade M6 for A4 conversion
- Not your ordinary bleed question. Oh the noise!
- which fluid do you use?
- Clutch ?????
- Problem after clutch install
- Flywheel Dowel Pin
- T-56 wants to grind on the down shifts.
- sequential manual tranny
- Adjusting my master cylinder and the retaining clip FLEW OFF!
- Which Gm Clutch For Lt1 Car
- were to buy cheap stock clutch?
- tough to get in reverse
- Urgent...need Help Quick ..
- clutch bleeding issues
- Clutch problem on daily driver.....need help!
- Textralia 1000-mile Checkup... PICS & Concerns
- BBC with LS1 t56
- help just installed new clutch etc and having shifting problems
- Spec Question
- T56 trans to bellhousing bolt thread pitch?
- Where to buy shims???
- Help!!
- leaky slave
- Textralia install
- guideplate/shift selector
- t56 flywheel weight?
- Problem with M6 after 2 hour trip!
- Replacment disk for RAM HD
- torque specs
- Shifting at wot
- Ram PowerGrip HD for those interested
- what socket will fit the t56 clutch slave bleed valve?
- T56 Rebuild Article in Popular Hot Rodding
- RPM's
- Problem with spec install! HELP!
- Part numbers for 01+ slave and master?
- Can i run factory turned flywheel with Spec 5
- How important is a new flywheel w/a new clutch kit??
- Early Engaging Textralia Clutch... Solutions?!?!
- No more black/gunky hydraulic fluid
- master cylinder problems
- Will drill mod fix my clutch sticking problem
- Clutch and bellhousing for 900hp
- Drill Mod
- M6 grinds going into 3rd on about 1 out of 100 shifts. Solution?
- new hydrolics needed
- clutch stuck to floor
- Clutch feeling stuck down when racing.
- Is This Normal
- t56 ls1 master cylinder part #
- F & Y body tranny differences
- T-56 bellhousing pattern for 6.0L?
- Clutch help pleazzzzz??
- What if I do this? Light weight flywheel & 4:10s.
- Noisy transmisson HELP!!!!
- neutral safety switch help?
- i need a ls6 flywheel!!!
- problem..HELP PLEASE M6
- Carbon Fiber syncro's?
- newbie shifter question
- M6 Clutch
- Finally 500 miles on LS7 clutch!!!!!
- LS7 Clutch and Flywheel for Under 500
- Please HELP !
- Another One For The Experts
- problem with going into gear
- Anybody have pics of their shifter?
- How much does it cost?
- rubuild kit
- Slipping Clutch?
- did 01-02 T56s come with steel 3-4 shift fork?
- LS7 clutch on stock T/A
- Are all T56's Same?
- differences in lt1 t56 and ls1 t56???
- All clutch and no gas
- Fast 2nd to 3rd Shift Problem...
- Got my Textralia clutch from Byunspeed today!!! But parts are missing!!!
- Balance Problems With Re-surfaced Flywheel??
- MCleod Master Drill Mod
- Is it realy necessary to resurface your stock flywheel?....
- buy a spec flywheel or resurface the stocker
- RPS Clutch
- Ordering clutch tonight!!!
- Difference between ls7 and ls2 flywheels?
- When is it easiet to change shifters when the trans is out of car or in?
- Need help with shifting on N20!!!!!
- Spec Stage 3 and Daily Driving