THE YOKE ON THE DRIVESHAFT IS WRONG!!!! I ordered the carbon fiber shaft from Hinson..and it should of came with a Nissan back side to mate to the Nissan rear end..and a GM front side..well it came with both Nissan ends!
No, instead of waiting for a call I might not get..I went ahead and called the DS company directly..the guy I spoke with said they put a ford yoke on the order form(???) so he went ahead and sent me the right yoke free of charge I just have to send this one back. =) I should have it Friday. Im gonna let my fuel rails sit one more day before I run anymore gas through them..(the sealant takes 72 hours to set )then set fuel pressure...and the wiring plug should be here today..so im hoping to have this thing fired up Thursday...possibly driving Saturday so I can make it to a car show on Sunday.
__________________ 2004 Nissan 350z/LS2/PT88--Project 88 has begun.
More than enough room but no im not using it. Ive never used A/C on any of my vehicles and even removed it on the stock v6 engine. Now theres even more room and a downpipe will fit beautifully where the ac comp used to go.
__________________ 2004 Nissan 350z/LS2/PT88--Project 88 has begun.
Also, I could not get my fuel rails to seal up no matter what I did. Fuel would leak out of the ends...so I went ahead and welded the ends right onto the rails...they look like shit now..but they dont leak. Im buying another set of rails today and im going to put them on after I get the car up and running.
__________________ 2004 Nissan 350z/LS2/PT88--Project 88 has begun.
More than enough room but no im not using it. Ive never used A/C on any of my vehicles and even removed it on the stock v6 engine. Now theres even more room and a downpipe will fit beautifully where the ac comp used to go.
Of Course... you live in Connecticut. Who needs A/C when its 50 degree in the Spring
Me on the other hand... my LSX C3 has no air either and I live in Florida.
But all C3s have T-TOPs!!!
__________________ 2000 SLP SS M6 few mods. (sold)
2000 FRC cam and headers (daily driver)
1977 Corvette LSx cam and stall with a CARB!
Last edited by holley505; 04-29-2009 at 05:52 PM..
hey snyper, your build is going great. I wish you would take the time to stand by your word. I purchased a worn out clutch, fly wheel and slave cylinder in march. As you know I have attempted to contact you about the missing slave cylinder. You said it was shipped but I have not received it. Please do the right thing and refund my MONEY! Paypal is now involved.
simply bad asss...nice clean swap and a job well damn done...now make sureyou get the right insurance coverage on it...how much did this whole swap cost you anyways?
__________________ 346 Forged bottom end,P&P 241's, Lunati cam, Ram VDS Pkg, Stage 2 TICK PERFORMANCE T56, moser 12 bolt...sooon #'s and 200 shot
old times with just exhaust and Dr's..
12.56 @ 110 - 1.85 60ft
