10 Second Club - 10 second M6 cars CHIME IN!!!

what are you running in th 1/8th??

and if you could please include:

1/8 and mph.... horsepower/tq .... engine n power adder? and gears and weight


thanks


I ran a 7.10 @ 98.9mph w a 1.54 60'

I know I can do better, Im still getting used to the setup...

I wonder how close I am to a 10 second pass...

6.95- 1/8th @100.56 1.55- 60' 10.82 @127.36

car dynoed 395/380ish rwhp through 9", had more in it but opti crapped out and haven't been back since. 3.89 gears using 26-11.5-15 ET Streets launching @ 5800. full weight minus ac pump spraying 150 shot. can't wait to get back to track this year with weight reduction and better suspension, hoping for 10.40-10.50 with 1.40ish 60'
94 forged LT 1 , gm 847 cam and bolt ons

damn... my times are pretty close to yours.. and so is mph...

so that run I had was probably a 11.0 run

1.51 60ft, 6.96 - 1/8 @ 99.98, 10.85 @ 128.02.
I running a mild H/C 346 with a 125 hit. The car also has a moser 9" with 3.89's and Hoosier QTP 27x11.5-15's
6.95- 1/8th @100.56 1.55- 60' 10.82 @127.36

car dynoed 395/380ish rwhp through 9", had more in it but opti crapped out and haven't been back since. 3.89 gears using 26-11.5-15 ET Streets launching @ 5800. full weight minus ac pump spraying 150 shot. can't wait to get back to track this year with weight reduction and better suspension, hoping for 10.40-10.50 with 1.40ish 60'
94 forged LT 1 , gm 847 cam and bolt ons
Im shooting for the same goal. I still need shocks, a good sway bar and a little weight loss. I'm also wanting to get my 60's down to a 1.4x with some 10.40's to back it up.:cheers:

never have ran the quarter but i have beatin many ten second cars at our track. im full weight and make 470/450 + a 150 hit 1.6 60 fts 26/11.5 et streets and still rollin on my 10 bolt! nock on wood again.....

7.071 @ 97.x

456rwhp 346 cam only

3222 weight
4.10s 26" tire

A 7.31 @ 97.53mph with a 1.677 60' gave me the time in my sig. It's tens or bust this year!

i think i went 7.2 and went 11.2

i think i went 7.2 and went 11.2

details on setup please...

same here
a few 7.22-7.25 @ 96.8-97.3 for me were 11.2x's

232/234 cam only 3675lbs then a 110rwhp dry shot

patriot heads, f11 cam, 9" with 4.30's, 75 shot
right at 400 rwhp on motor, 485 is think it was on the shot

60': 1.561
1/8: 6.885 @ 100.37
1/4: 10.746 @ 128.20

car definitely has more in her but shes going under the knife for a turbo build this summer and i dont know if ill get to the track again before i tear her down

I'm shooting for low 10's at least this year. No times on the setup for another few weeks but 10's should be easy enough.

Full weight and it made 574whp on an incomplete pull (twisted the drive shaft) through a 9" w/3.73's. Engine is a GT76'd 383.

i went a best of 7.08 @ 99.25mph w a 1.53 60'....

best 60ft i got on nitrous was 1.64 spinning. going to the track tonight, man i would be nice to pull some 1.55's

more?

A lot of you are on nitrous... what about No Nitrous?

60ft..1.53
1/8...6.92@99.57mph
1/4..10.84@125.83mph

466rwhp/411rwfts N/A, Cam only with bolt ons.Stock 2.56 gears.

I saw the vid of that pass Tony. Sweet car and nice run.

I saw the vid of that pass Tony. Sweet car and nice run.

Thanks! And sorry to the OP, just realized that this was a manual thread.LOL!!!:emb:

60ft..1.53
1/8...6.92@99.57mph
1/4..10.84@125.83mph

466rwhp/411rwfts N/A, Cam only with bolt ons.Stock 2.56 gears.

Well this gives me hope, even though, you're an auto... because your trap is somewhat high for an auto, but you're a vette... You're more aero dynamic and are lighter... I think with me shaving just a few pounds off my car, I should have no problem reaching your times.

thanks anyway

60 ft 1.68
1/8 6.85
mph 107.01
1/4 10.41
mph 138.78
02 Z06,6 speed,3.42 rear,26/11.50-16 MH slicks,TTix 402 with meth!

turned a few 10's this weekend. ms4 cam, tdp clutch, moser 12 bolt, 3.73's, mt 26x11.50x16. 150 wet shot, 80+ degree weather, 2000ft d/a, and road race suspension. she has 10.40's in some good air.
1.54 60'
6.91@ 101
10.78@128. full weight car all accessories race weight of 3640.

turned a few 10's this weekend. ms4 cam, tdp clutch, moser 12 bolt, 3.73's, mt 26x11.50x16. 150 wet shot, 80+ degree weather, 2000ft d/a, and road race suspension. she has 10.40's in some good air.
1.54 60'
6.91@ 101
10.78@128. full weight car all accessories race weight of 3640.

damn man, I feel like my 7.08 @ 99.25 (1.53 60') run was like a 11.00... Its pretty close... You're weight is a bit less than mine.. I know with some weight reduction Ill easily get there..

Closest I've come to 10s

1.53
7.113 -1/8
97.64 -MPH
11.162 -1/4
122.95 -MPH

I bet that run would have been an 11.0 at 125-126

Closest I've come to 10s

1.53
7.113 -1/8
97.64 -MPH
11.162 -1/4
122.95 -MPH

I bet that run would have been an 11.0 at 125-126

yeah man.. we shall see...

I took out my airbags and Im gonna disconnect my AC belt..

im planning on doing a 6.9x run at 100mph this thursday... we'll have to wait and see..

if not, I guess its cause of the hot weather and ill have to do more weight reduction...

not a 10 but i am very close + i have only made 1 1/4 mile pass
1.54
7.07 @101
11.02 @129

Speeds are good and damn that is close. It's like getting left with blue balls.

i went 6.82 @ 103.2 and 6.87 @ 104.44 with shitty 1.57 60ft's mods in my sig .....that was when my car was a 6 spd car went 10.61 and 10.62 at 129 with a bad clutch

1.47
1/8 6.7
mph 102.9
1/4 10.50
mph 131.9
another
1.54
6.77
103.2
10.54
134.3

1.41 60'
6.4x 1/8
10.02 @ 136

Trex cam, stock 241 heads, 150 shot.

60' 1.81

1/8th 7.40

100.41

Its a fully loaded Z28

No 1/4 mile times yet! Dana S60 with 4.10's with 28x11.5x16 MT, NA