narcszm
04-25-2009, 11:47 PM
This is a custom cat-back that will require a modified I-pipe. Installation only requires unbolting the panhard support (not the panhard bar itself). A flange or slip-fit will need to be added to the I-Pipe, as there is only straight 3.5" pipe forward of the axle. These are all mandrel bends from Stan's Headers in Auburn, and the pipe has only been pinched in a couple of spots for clearance. The "muffler" is a Dynomax bullet and reduces some of the rasp and resonance, but really, this pipe is only to get the exhaust from under the car out the back. It doesn't really do much to quiet the car.
You'll need get the 3.5" gasket from Stan's. I can't find the one I had.
$100.
You'll need get the 3.5" gasket from Stan's. I can't find the one I had.
$100.