Small Block & Big Block Chevy Specific - 95 Z dyno

Did better than i thought, it is a .040 small block with a comp XE288HR, home ported vortec heads with stock valves, the slamm performer intake, hyper flat top pistons, stock bottom end with ARP bolts, pace setter shortys and straight piupe all the way out the back, holley 750 carb, HEI dist.

311 RWHP and 350 RWTQ

Not bad for some junk i threw together to drive:

http://i157.photobucket.com/albums/t74/ZONES89RS/th_95zpull.jpg (http://s157.photobucket.com/albums/t74/ZONES89RS/?action=view&current=95zpull.flv)

http://i157.photobucket.com/albums/t74/ZONES89RS/th_95zpull2.jpg (http://s157.photobucket.com/albums/t74/ZONES89RS/?action=view&current=95zpull2.flv)

cool. been a while since i seen that hood.
was this thru the t56? any more power upgrades coming soon?

Yea, it was thru the T56, nope, i am selling the car to my buddy Joe who is going to install a bigger intake and full length headers. This was a Mustang Dyno also.

Those are nice numbers, glad to see you got the car looking nice after the encounter with a ditch. I cant wait to dyno mine after the H/C and carb swap.

Yea, it was thru the T56, nope, i am selling the car to my buddy Joe who is going to install a bigger intake and full length headers. This was a Mustang Dyno also.

dont seem like the intake is the prob. just the headers should wake the motor up. what is the scr and dcr for the motor?

Well, it falls short in RPM because of the two.


Those are nice numbers, glad to see you got the car looking nice after the encounter with a ditch. I cant wait to dyno mine after the H/C and carb swap.

That is still the same nose and fender, i just did what i could to make it decent.

that car is starting to come around. and now your going to sell it?

Looking good, Zane!

Thanks man!


that car is starting to come around. and now your going to sell it?

Yea, just wanted another third gen man, just dont really feel the 4ths, i know i am just weird...

good runs, keep it up

how much was the hood? does harwood still make them?

Still make them that i know of, got it for 250$ from a friend.

Thanks man!




Yea, just wanted another third gen man, just dont really feel the 4ths, i know i am just weird...

That's not weird. :devil:

You sure do like those straight pipes don't you?? :D