Dyno & Bench Racing Forum - getting my 408 motor dynoed tomorrow!(hopefully)

Im hoping to see atleast 550rwhp with this setup. what do u guys think?

Engine
408 CI
11.37:1 CR
Ported FAST 90mm intake
NW Ported 90mm TB
Yella Terra 1.7 Rockers
Morel Link bar Lifters
TFS 235cc heads with 64cc chambers
Custom cam-246/254 113LSA (see cam card)
Kooks 1 7/8 LT headers
Kooks ORY
Magnaflow Catback with cut out
Tsp Ported LS6 Oil pump
Slp Lid
Stock MAF
FTRA
Underdrive Pulley
No AC

Trans/Rear/Suspension
07 Zo6 trans Rebuilt
Monster Level 4 clutch/flywheel
Tick performance adjustable Master Cylinder
Hurst Short shifter
Stock suspension, rear end(2.73) and driveshaft.

Wheels/brakes
17" zo6 motorsports w/ 275 street tires
Rotor pros dimpled and slotted rotors

Yes I know i need to upgrade the rear end and suspension and everything. Working on it....

Sounds pretty damn stout, through the 10 bolt I would guess 563rwhp ;)

Ok well we did 5 runs first was a baseline of 478rwhp. on the last 2 runs things started to go south. the pcv valve system came undone from too much crankcase pressure and on the last run the the crank pulley came off and broke the front oil seal. we had to stop tuning because of that but on the final run it made 515rwhp. Shes still got more in her!

http://www.youtube.com/watch?v=jbl4zNitsDU
http://www.youtube.com/watch?v=Z10WqZeafa8
http://www.youtube.com/watch?v=ZtEvAEHbOxQ
http://www.youtube.com/watch?v=jPJVnoYRLHQ
http://www.youtube.com/watch?v=rG_IO0zEJXo