Forums

Pontiac GTO 2004-2006 - BMR Drive Shaft Safety Loop 04-06 GTO

View Full Version : BMR Drive Shaft Safety Loop 04-06 GTO

JeremyF

10-01-2009, 02:08 PM

Never been used, new from BMR $99.95. Will sell for $SOLD in the lower 48.

From BMR's site:

Most tracks require driveshaft safety loops for ET's quicker than 12.99 in the quarter. Our NHRA legal safety loop welds onto the factory floorpan reinforcement and has locating holes for proper positioning. Two piece design allows installation without removing driveshaft and will fit driveshaft diameters up to 3.5". Available in Black Hammertone or red powdercoat. NOTE: Will not clear '05 resonator.

http://www.bmrfabrication.com/GTO.htm

http://i28.photobucket.com/albums/c205/juicedss262/IMG_2374.jpg
http://i28.photobucket.com/albums/c205/juicedss262/IMG_2375.jpg
http://i28.photobucket.com/albums/c205/juicedss262/IMG_2376.jpg

quadman

10-01-2009, 04:10 PM

Jeremy,
want to trade? 2 sets of trickflow pushrods that we talked about (8.100 and 8.150 i think) for the driveshaft loop? for ETP and RHS heads.

Gregg

JeremyF

10-01-2009, 04:59 PM

Deal! :chug:

quadman

10-01-2009, 05:21 PM

JeremyF

10-01-2009, 05:26 PM

great! either PM me your mailing address and i'll send the pushrods to you............or................since my tune needs touched up and i'm hoping to see you in Nov in Gettysburg, i can bring them with me.
(check your thread in the NorthEast section on the GTO board....lol)

He's always so packed down with intakes and throttle bodies when traveling up there, how about just sending them back and forth. PM me your addy and I'll get them out to you and then just send the push rods back.

Thanks

Dan
Fasterproms

breze84

10-01-2009, 06:17 PM

Great Deal, You can never be to sure with these shitty DS's..... Next spring im getting one for sure....