Western Classifieds - 4.11 Truetrac 31 spline 9" center section...

Going to be switching to a 4.30 35 spline spooled setup, so I'm kinda posting this up as a feeler right now as I have not ordered my new center section.

Gears are Motive 4.11s, dead silent compared to my stock 10 bolt.

31 Spline Truetrac, no dragstrip passes, quiet and works fine.

The gears, truetrac and bearings have about 1k miles on them.

Yoke is a 1330, however I will include a new strange 1350 yoke that is NIB, and I'll throw in a 1350-1330 conversion u joint if you'd rather not switch them out.

600 obo

Located in Upland 91784

bump for a good price

thanks man i could get more interest in the fs section but dont feel like shipping... its fuckin heavy

Is this the complete third member or just the Trutrac and gears?

What kind of case is it? Pinion support?

if you decide to ship, let me know.. I'd have to find an adapter u joint from a 1310 to a 1330.. I'm currently running a 1310 to a 1350, but not sure if I want to change it if everything is dead silent, like stated..

Complete center section. I couldn't tell you without opening the case what size the bearings are, my guess would be 3.062. its a stock case from moser, stock 28 spline pinion support. Yea it could be upgraded, but the weakest thing on the pumpkin right now is the 1330 yoke. Its got a solid crush sleeve, you won't change the gear setup by swapping the 1350 yoke out as long as you tighten the pinion nut the same number of turns.

Can you send me some pics? Thanks.

dcfirehawk@cox.net

gonna be pretty hard since its still in my car... still trying to find the best deal on a new center section and axles, when i have them I can snap some pics.

up up up

up up up... my new center section should be here next week so I need this thing gone...

I may be interested, but would like to see what you are selling. If the internals that you describe are correct, that's fine for me on those parts. Would it be possible for you to take a picture of the third member/pinion yoke outside area? Thanks.

no problem man, i need to measure the axles anyway, so i'll pull the pumpkin too. my next day off from work isn't until thursday so bare with me