Manual Transmission - how to make master clyinder adjustable???

i know its in here somewhere but i cant find it no matter what i search.... i got a ram clutch kit going in my car since the 4 month old spec stage three just took a dump on me..... i gotta call those guys up and see if they can give me something for this..... i broke it in properly and all.... but anyway please if someone knows a link or anything on how to make the master cylinder adjustable post it haha..... or if you know where i can buy one for decently cheap.... mcleods is going for 310 bucs which is just crazy for me...

i know its in here somewhere but i cant find it no matter what i search.... i got a ram clutch kit going in my car since the 4 month old spec stage three just took a dump on me..... i gotta call those guys up and see if they can give me something for this..... i broke it in properly and all.... but anyway please if someone knows a link or anything on how to make the master cylinder adjustable post it haha..... or if you know where i can buy one for decently cheap.... mcleods is going for 310 bucs which is just crazy for me...

Im in the same boat as you! My spec 3i went out on me after just under 5,000mi. It screwed my new billet flywheel up too. Now I put the ram 910 in my car and I cant get it to disengage :bang: . I tried making my own adjustable master and it still won't work right. fucking piece of shit spec clutch!

http://www.ls1tech.com/forums/showthread.php?t=8284&highlight=make+adjustable+master

yeah dude!!!! fuck spec!!! shit why didnt making your own master work.... this is so frustrating!!

the ram adjustable master is just a stock unit made ajustable already for you.... i finally found it for 166 and some change....which still sucks since im a broke ass college kid

does anyone know where you get the ball end to make this??? does anyone have pictures

i did a write up with pics a while back, lemme see what i can dig up

does anyone know where you get the ball end to make this??? does anyone have pictures

I got my parts from McMaster Carr. Here's the parts I used:

1 90494A231 Grade 2 Plain Steel Hex Thin (jam) Nut, 3/8"-24 Screw Size, 9/16" Width, 7/32" Height 1 Pack

2 2573A33 Hex Rethreading Die, Right Hand, 3/8"-24 Nf, 25/32" Width Across Flats 1 Each

3 6072K175 Zinc-Plated Steel Ball Joint Rod End, 3/8"-24 Right Hand Female Shank, 3950 Lb Load Cap 1 Each