Project Comments & Discussion - SAM 500"LSx

that is one bad mofo, Gray did you guys get any videos of that thing

I do love these big cube setups they've got in the works...

that is one bad mofo, Gray did you guys get any videos of that thing


Yeah, I got a few dyno videos and what not. I will try to get one uploaded and hosted tomorrow so you guys can hear this thing run.



Thanks for the kind words. This thing should be installed soon after we get back from PRI in Florida. Finally got in the other suspension pieces we needed! :drive:

So that engine is going into Linda's car? :D

So that engine is going into Linda's car? :D


Yes sir it is! LOL! From the old 375" Solid Roller to the 500"

I remember when Linda was practicing her burn-outs in the parking lot, haha!

-Ben R

I remember when Linda was practicing her burn-outs in the parking lot, haha!

-Ben R


Thankfully the Line Lock is fixed and it does it a little easier now ;) Good times!

Thankfully the Line Lock is fixed and it does it a little easier now ;) Good times!

At least there is no fence for her to almost take out now! :drive:

Yeah, I got a few dyno videos and what not. I will try to get one uploaded and hosted tomorrow so you guys can hear this thing run.



Thanks for the kind words. This thing should be installed soon after we get back from PRI in Florida. Finally got in the other suspension pieces we needed! :drive:
would it have been possible to do a solid roller set up? if so why didnt you guys lean towards it?

Those options are out of our control. No big worries though, there are going to be other crazy ERL motors out there :D!

Those options are out of our control. No big worries though, there are going to be other crazy ERL motors out there :D!
i see, just a curious question i would ask, either way you look at it, that thing needs a doctor cause its so sick :hail:

Linda won't need any help learning to do burnouts with the 500 inch ERL. Now Linda will have to worry about NOT spinning the tires all the time! HAHHAHAHAHA! Good luck with everything Gray and I can't wait to see that crazy car run down the track!

do you have overlayed dyno graphs of the LS7 intake manifold versus the BECK sheetmetal manifold, i'm interested to see what that looks like.

I can certainly set one up when I return to Houston. I am currently here in Orlando, Fl at the PRI convention.

Regards,

Gray
www.SAMracing.com