Stereo & Electronics - quick lumber wiring question




View Full Version : quick lumber wiring question


3800RS
03-14-2007, 12:47 AM
the harness under the pass side seat of my sisters 99 trans am. i think its a 6 pin, not positive. the orange and white wire appears that someone ripped them out of the connector. is there any way i can just tap these into the other end or something b/c the lumbar doesnt work


3800RS
03-14-2007, 03:12 PM
anyone ?

dragonrage
03-14-2007, 03:38 PM
Sure, why not? As long as they go to the right wires...

Wonder why someone would rip them out though...


3800RS
03-14-2007, 03:50 PM
yea but the thing is that the other end of the connector doesnt have the same color wires so i dont know what to tap into

3800RS
03-14-2007, 09:48 PM
paging whitebird ... do you know the wireing on this man ? thanks

WhiteBird00
03-15-2007, 09:40 AM
As you've mentioned, the connector under the passenger seat has different wires on opposite sides of the connector. In the listing below, the left color is the female side of the connector (the side that comes from the driver's side switch) and the right color is the male side of the connector (the end that connects to the air control module.

Gray....Gray
White....Pink
Orange....Orange
Black....Black
Brown....Purple
Purple....Red

3800RS
03-15-2007, 06:17 PM
thanks man, your the best. so i just have to tie in the orange to the orange and the white to the pink correct ?

WhiteBird00
03-15-2007, 08:53 PM
thanks man, your the best. so i just have to tie in the orange to the orange and the white to the pink correct ?
Yup, if those are the only damaged wires, that's all you have to do.

3800RS
03-15-2007, 09:21 PM
sweet, thanks man