Small Block & Big Block Chevy Specific - Gen I SBC with LT1 accessories?

Is that possible? I was planning on using an electric water pump. I know that the bolt bosses in the cylinder head are the same, but I was wondering if the fuel pump casting boss would interfere with the accessory bracket on that side. I have a carb'ed LT1 in the car now and I want to just go back to a traditional SBC, but I don't want to ditch my accessories.


Thanks for any help...
-Garrett

They all will work. You will either have to go with an electric fan or a reverse rotation mechanical fan for the reverse water pump.

the LT1 accesory bracket will put your pullies too far back for your crank pulley. unless you can run an LT1 balancer on a sbc...

You can. Everything will swap over.

There are a few bolt holes missing but it bolts up ;)