Small Block & Big Block Chevy Specific - Startup Vid of new 385ci Marine Stroker



PDA
Ryan02SS
03-22-2008, 05:00 PM
The boat is ready to hit the water now. Waxed, new motor in and new HD drive on. I fired it up yesterday to make sure everything was right. Weather looks promising for next weekend. Sunny 60's so the water test is not far away. :D I just need $1.50 gas to come back.... :mrgreen:

http://www.youtube.com/watch?v=ORkMT3JMWu8

Engine Specs....

010 4 bolt SBC, bored .040", 0 decked, line honed,
ESP 4340 3.750 crank, ESP 6" 7/16" H beams, Mahle forged FT's 5cc, C77H bearings, Hines Balanced
Melling Racing #10555 oil pump, Hamburgers 7qt marine pan, full length windage tray.

FluiDamper harmonic balancer,
AFR 190cc heads, 73cc, further ported by Carl McQuillen Racing Engines, Isky 6105 dual valvesprings,
Marine Kinetics "RMbuilder" custom Hyd Roller 234/240 .580/.568 112+4
Morel Retrofit Hyd Roller lifters
Smith Bros .083" wall pushrods
Edelbrock RPM Air Gap port matched to AFR port
Holley HP 750 DP
Lunati Voodoo Widebody 1.5 roller rockers
GLM aluminum manifolds
FastGlass Stainless 22" long dry risers
Full MSD ignition setup, coil, wires, dist, 6AL,
10.07-1 SCR

http://usera.imagecave.com/ryanootj/DSC00365.JPG

http://usera.imagecave.com/ryanootj/DSC003642.JPG

http://usera.imagecave.com/ryanootj/DSC00363.JPG

jmm98LS1
03-24-2008, 12:32 PM
Sounds badass!!
1 FMF
03-24-2008, 12:58 PM
post a vid of your avatar !


why not 1.6 rockers?

Ryan02SS
03-24-2008, 04:08 PM
post a vid of your avatar !


why not 1.6 rockers?

The lobes were designed around a 1.5 rocker ratio vs the 1.6.

I wish I had a video of the avatar! :D
Badass355ciz28
03-29-2008, 10:11 PM
sounds pretty good, bet that will make some waves now