STILL 2 SLOW

iTrader: (3)

So I bought this short block about three years ago and planed to swap it into my truck. I bought it off a local guy who took it out for a 408. I had a set of 241 head laying around from my old car and decided to use them for my project. I did some minor polishing on the heads for a little better flow and then sent them out to the local machine shop to have them milled and a valve job done. I then put the heads on with OEM head gaskets and ARP head bolts. I did bought a LS6 cam, springs, and pushrod and installed them as well. Everything is installed and I will not seporate, the only thing not installed are the pushrods. Thats because the heads were milled and the stock ones are a little too long, but I also have a stock set of 853 you can use if you want stock compression... Motor Is SOLD!!!
Short block has 40k on it.
Heads have been Milled 0.030 and Valve job done 0 miles
Arp Head bolts and Factory gaskest 0 miles
LS6 Cam, Springs, Pushrods 15k


I am located in Southern California and will NOT ship

STILL 2 SLOW

iTrader: (3)

Another Pic with the valve cover off

STILL 2 SLOW

iTrader: (3)

All pm's replied to...

STILL 2 SLOW

iTrader: (3)

For the night crew...

STILL 2 SLOW

iTrader: (3)

Any other questions guys???

candlelit

iTrader: (21)

If I was in Cal I'd be all over that!

STILL 2 SLOW

iTrader: (3)

Thanks man. I have alot of pm's with people who say they want it but no ones paid me yet. oah well we'll see

STILL 2 SLOW

iTrader: (3)

Bump...

ferrari360man

iTrader: (1)

how much would shipping be to kenner la 70062? pm me if need be.

Beaflag VonRathburg

iTrader: (176)

^ You should read the last sentence of his original post.

94'BLKBRD

iTrader: (76)

Where in So Cal are you located?

STILL 2 SLOW

iTrader: (3)

I live in Victorville, its about 40 miles north of LA

justablur1

iTrader: (14)

geez...wish this was close by

STILL 2 SLOW

iTrader: (3)

I dont want to ship it but I will deliver up to a 150 miles or so. But I want to split the cost of gas...

Just letting everyone else konw...

94'BLKBRD

iTrader: (76)

Any pictures of the bottom end?

STILL 2 SLOW

iTrader: (3)

I took some pic's today after work. All the cylinder walls look great but looks like two of the rods have a little rust on them. You can see it in the first pic, the two middle jurnals. When I got the motor I put oil on the cylider walls and the pisten rods. Looks like I missed a little on the rods, or it all ran off. The cylinder walls are good, that whats most important...

And I forgot that I put on a new timing chain when I did the cam. Last pic

STILL 2 SLOW

iTrader: (3)

Motor is sold.... Thanks Guys.....