New price Update 1000HP combo parting out

Schurters LT1 · 07-03-2008, 06:17 PM

Hey Guys,

Well i am selling off everything, i have all the right parts here to make a 600-1000hp car all hi-end parts SO PLEASE NO LOW BALLERS

This is off my 95 T/A

I HAVE PICS OF EVERYTHING I WILL POST OR I CAN EMAIL THEM

Vortech Ysi Z8's brackets , with my custom 4" suck side and air filter
cog pulleys 36mm, 78 teeth crank/30 blower
8 rib pulleys 8" crank pulley with spacers/ 2.65 blower pulley with belt
FMIC and all the piping with extra clamps and hose
vortech mondo BOV

$4000.00 or i can split SOME OF THIS UPf

Alky control kit
singal kit & dual kit as well, with an extra pump $500

Nitrous Outlet elbow $300

Vic Jr intake with fuel rails its fully ported and matched to the heads this stuff is a one off
matching AFR 220 heads
These are Z8's old AFR heads(220) that were ported by GTP that flow 330cfm@.600 and mating Vic intake you will not find another set of heads like this with shaft mounts 1.7r $3500.00

85# Delphi Low Impedence - Flow Matched $300

RACETRONIX / LONNIES PERFORMANCE Double Pumper kits - - Will support OVER 1000RWHP
$500 with the wiring kit from racetronix

upper/lower A arms BMR/Sphon $500 (new)

front Qa1 with 250lbs springs and shims $300

sphoon TQ arm $400

sphoon SFC CM $200 (new)

short block 355.....blower set up
eagle rods 4340
eagle 4340
Je blower pistions
4 bolt mail
balanced
ATi extra keyed crank
e-water
custom Bret B blower cam
Morrel's lifters (new)--------------$3000 or can part out the parts

Accel Dfi with fast track wiring, WBO2 with extra pcm/dataloger , dual synic dizzy, pro-key $1200

9" from DLS
35 spline axles
detroit locker

drive shaft for M6 tranny to match up with the 9" to handle 1000hp $2500.00

1 3/4 jethot LT header with Y-pipe $400
2 magnaflow cats new $175
borla cat back with adj plate $400

Canton LT1 Valve Covers $200 new

weld wheels
15x5 front with tires
15x10.5 with 7.5 bs and hoosher slicks $700

IF DOING PAYPAL ADD 3%

obo