Microedge and LM-1 Config

SkullV · 07-04-2009, 01:23 AM

Hey guys. So I just set up my Microedge to work with my LM-1 wideband. It only works with the factory analog output signal which is only 1V wide (10-20afr). I was wondering if there was anyway to get the Microedge to read 5V wide and if it is even necessary if it is just being used as an AF lean cutoff?

I'm still learning about tuning and nitrous here so try and be nice!

van383 · 07-04-2009, 09:55 AM

i had to find another to read what my lm1 said i think mine is on the lc2 setting to be accurate.

SkullV · 07-04-2009, 03:00 PM

anyone else?

SkullV · 07-05-2009, 12:27 AM

Does anyone know if any of the preset wideband controllers in the microedge read from 0-5V and what afr each of these values corresponds with?