I have a custom made, one of a kind, carbon fiber shroud. This was laid up by a resin infusion method by an extremely good fabricator. There are NO pinholes, voids or any other defects in this carbon as can be seen even in vacuum molded products. I did the custom cutting and fitting for my 2001 Camaro. It attaches to the factory radiator support and front brace bolts.

Here are some pics:





My application was for a FIPK intake but it will work just as well with a lid
as the cutout is already there.

This cost me over $250.00 for the layup plus approx. 10 hours of fitting and cutting time.

The shround has NEVER been used, only fitted and boxed back up. I sold my car soon after completing.

Asking $150.00 BO plus shipping.

Bryan
parbreak

 

Very cool piece. Would make someones car really stand out.