I'll take it

 

Updated the Thread on parts for sale and sold. As of 2:24PM CT

Thanks again fellas

Jeff

 

TTT Some parts are now available. That were pending.

Thanks

Jeff

 

MAF here. Sending PM

 

PM sent

Jeff

 

i'll take the screened maf. pm sent.

 

Very very interested in the Z06 clutch if it is still available....

 

Will do. I will put you in line for it. I am waiting on the guy's final descision today.

Thanks

Jeff

 

1 Maf is sold. Other is pending.

Jeff

 

Fryelance sorry the clutch is sold

timing chain pending

TTT

Thanks again to all who have purchased so far. As well I was able to get every part shipped out the same day the money was transfered to paypal. Even the shortblock . I am sure there are some ppl out there that could use a good cam spring kit, harden push rods or a good set of stock heads. Hopefully they will find there way to this thread.

Jeff

 

The Double roller timing chain set is now sold As of 9/23/05

Thanks

Jeff

 

Why does the cam look smaller in diameter at the end I dont remember my cam being like that. I m interested in it for my 408 build.

 

Well I am not sure. But I do know that it was in my ls1. And there is not one single problem with it. The only thing I can say is the way I took the picture caused it to look funny. If you are really interested I will snap off some pictures for you. Just leave me a pm with your email address...


Thanks again

Jeff

 

7.400 Push Rods still available?

 

sent u a p/m

 

PM sent
No they are sold.

Thanks fellas

 

Got it!

 

PM sent on the 241 heads

 

Sold to a sponsor on the board. Thanks

Jeff

 

Here is a dyno sheet on my cam. Only boltons were LT's,TSP Catted Y, TSP rumbler catback, K&N FPIK kit, ported oil pump, double roller timing chain, harden pushrods, comp 921 spring kit, svo injectors,racetronix PNP, PCM tune.