Parting 1999 Trans Am
This will sound odd but I need these if you want to sell them:
Drivers side kick panel, where you put your foot down on has a long screw that holds the plastic foot area down, I need that long screw. Also a few screws that hold the trim along the door sill too. Also, the rubber bumpers that go under your arm rest door? I need all of those too? 3rd brake light? Any luck with any of this?
Drivers side kick panel, where you put your foot down on has a long screw that holds the plastic foot area down, I need that long screw. Also a few screws that hold the trim along the door sill too. Also, the rubber bumpers that go under your arm rest door? I need all of those too? 3rd brake light? Any luck with any of this?
Thread Starter
FormerVendor
iTrader: (126)
Joined: Dec 2004
Posts: 1,399
Likes: 0
From: Richmond, VA
PM's sent to everyone who I had parts for.
Console is gone. I still have the lid if you need it.
Dash and driver door panel also sold already.
Coupler between maf and intake sold.
Console is gone. I still have the lid if you need it.
Dash and driver door panel also sold already.
Coupler between maf and intake sold.
Does this have the stock cat-back muffler with the over-the-rear pipe (uncut), hangers, tips etc.?
robertbartsch@kpmg.com
robertbartsch@kpmg.com
dude would you do 20 shipped on the lower part of the lid (the part that the lid snaps into) to 75043? if you will, pm me. and was that a ram air car?
Last edited by SEXICAN; Jan 10, 2008 at 04:05 PM.





