Auto Trix Passenger window kit availible at WS6store
I just did my pass window fix. Took me about 2 hours but I did not follow the directions precicely, I relocated the relays and soldered/heat shrinked the connections and ran the power wire inside the engine harness loom to make it all look factory. Window works beautifally, best fix/mod for the $.
Could somebody send me the directions/instructions on how to install the passenger window kit. I have the kit here but dont know how to install it. Thanks My email is tasupra@yahoo.com
Thread Starter
Closed ex-Sponsor Account
iTrader: (5)
Joined: Nov 2006
Posts: 461
Likes: 0
From: Tulsa, OK
I just did my pass window fix. Took me about 2 hours but I did not follow the directions precicely, I relocated the relays and soldered/heat shrinked the connections and ran the power wire inside the engine harness loom to make it all look factory. Window works beautifally, best fix/mod for the $.
No Prob!
Guest
Posts: n/a
do you guys know what it might be when you go to put up a window and it just stops randomly.. then you have to wait a lil to put it a lil higher up.. etc.. repeat til closed..
??? anything.. cause my driver side just started and the motor seems fine.. when it stays on.. id really like to not have to replace the whole motor if its just some stupid little thing
any input would be great!!
??? anything.. cause my driver side just started and the motor seems fine.. when it stays on.. id really like to not have to replace the whole motor if its just some stupid little thing
any input would be great!!
Thread Starter
Closed ex-Sponsor Account
iTrader: (5)
Joined: Nov 2006
Posts: 461
Likes: 0
From: Tulsa, OK
Most likely a dying window motor. Installing a new motor and our kit can allow for longer window motor life by allowing better current flow/voltage. The kit also takes the stress off of the window switch and puts it on the relays supplied.
9 out of 10 says you need a fresh motor. Check and lube your guides and regulator arms.
9 out of 10 says you need a fresh motor. Check and lube your guides and regulator arms.





