Comp Cams 7.375" Pushrods...in motor for 30 seconds.
Thread Starter
TECH Fanatic
iTrader: (17)
Joined: Mar 2006
Posts: 1,746
Likes: 2
From: West Chester, PA
SOLD!!! Comp Cams 7.375" Pushrods...in motor for 30 seconds. I have a set of Comp Cams hardened pushrods. They are part number 7795-16 and are 7.375" long.
I bought them as an experiment to see if changing my pushrod length by .005 would quiet my motor down. I literally installed them, fired it up, noted that the noise didnt change, removed them and put my stockers back in. I cleaned the oil off them...and thats it.
There is hardly any wear on the tips, everything is perfectly straight, they are almost brand new.
New from Thunder Racing they are $136. Ide like to get Sold!!! for them. They can be picked up in 19401 if you'd like.
Email, PM, respond to this thread. Thanks!
Justin
jgindin20@hotmail.com
I bought them as an experiment to see if changing my pushrod length by .005 would quiet my motor down. I literally installed them, fired it up, noted that the noise didnt change, removed them and put my stockers back in. I cleaned the oil off them...and thats it.
There is hardly any wear on the tips, everything is perfectly straight, they are almost brand new.
New from Thunder Racing they are $136. Ide like to get Sold!!! for them. They can be picked up in 19401 if you'd like.
Email, PM, respond to this thread. Thanks!
Justin
jgindin20@hotmail.com
Last edited by ghettocruiser; Jul 1, 2009 at 12:15 PM.
