MSD 6AL, Axles and misc stuff
Thread Starter
Joined: Aug 2006
Posts: 889
Likes: 0
From: Oviedo,Fl/Fairbanks,AK
ALL PRICES O.B.O.
I have a few things i sell so i can finish up my car.
-MSD 6AL never used-SOLD
-LS1 axle shafts drilled for 1/2 wheel studs
-LS1 T/A traction control switch-$10
-LT1 Surp Belt used but in good condition-$10
-Felpro valve stem seals for LT1-NIB-$10 shipped
-LT1 sun visors-$35 shipped- SOLD
-2 nitrous lines-$15 shipped
-SBC thermostat housing- $10 shipped
-I also have all the interior trim pieces for sale, headliner, T-Top holders.
If something isnt listed that you need shoot me a PM and ill see if i have it.
I have a few things i sell so i can finish up my car.
-MSD 6AL never used-SOLD
-LS1 axle shafts drilled for 1/2 wheel studs
-LS1 T/A traction control switch-$10
-LT1 Surp Belt used but in good condition-$10
-Felpro valve stem seals for LT1-NIB-$10 shipped
-LT1 sun visors-$35 shipped- SOLD
-2 nitrous lines-$15 shipped
-SBC thermostat housing- $10 shipped
-I also have all the interior trim pieces for sale, headliner, T-Top holders.
If something isnt listed that you need shoot me a PM and ill see if i have it.
Last edited by 3rdgen92maro; Jul 5, 2009 at 04:26 PM.
Thread Starter
Joined: Aug 2006
Posts: 889
Likes: 0
From: Oviedo,Fl/Fairbanks,AK
I dont have the LT1 harness for it. I just have whatever came with it from MSD. The timing set is a double roller setup so you will have to run a electric water pump to use it.


