Shifter, Lid, Clutch Adj. Master, U/D Pulley, etc
Thread Starter
Joined: Dec 2004
Posts: 1,294
Likes: 0
From: Dallas (Richardson), TX, USA
Shifter, Lid, Clutch Adj. Master, U/D Pulley, etc Hey all,
This is just a little garage cleanup.
SLP Lid - sold: This does not include the grommet for the IAT sensor as I reused it on my Procharger setup (which is why the lid is for sale). I have a K&N filter to go with it for a couple extra bucks.
OEM Hurst Shifter (LS1 F-Body) - $70: Approximately 60k miles on it. No issues with it.
Ram Adjustable Master Cylinder - sold: This is barely used... maybe 200 miles. I had to take it off not because it doesn't work but because Ram masters simply do not move enough fluid to actuate a McLeod street twin. I had to switch to the McLeod master to make it work.
Moroso Catchcan / Breather - $100: PN 85500. This is new and unused. I decided to go a different route with the PCV system. It was $140 from EPP.
SLP U/D Pulley - sold
Full set of stock '02 injectors (28.8 lb/hr) - $75: All the original O-rings are included and intact. These have about 75k miles on them and never gave me a problem at 400RWHP.
This is just a little garage cleanup.
SLP Lid - sold: This does not include the grommet for the IAT sensor as I reused it on my Procharger setup (which is why the lid is for sale). I have a K&N filter to go with it for a couple extra bucks.
OEM Hurst Shifter (LS1 F-Body) - $70: Approximately 60k miles on it. No issues with it.
Ram Adjustable Master Cylinder - sold: This is barely used... maybe 200 miles. I had to take it off not because it doesn't work but because Ram masters simply do not move enough fluid to actuate a McLeod street twin. I had to switch to the McLeod master to make it work.
Moroso Catchcan / Breather - $100: PN 85500. This is new and unused. I decided to go a different route with the PCV system. It was $140 from EPP.
SLP U/D Pulley - sold
Full set of stock '02 injectors (28.8 lb/hr) - $75: All the original O-rings are included and intact. These have about 75k miles on them and never gave me a problem at 400RWHP.
Last edited by Gauge; Jul 15, 2009 at 01:30 PM.