L@@k complete 6.0 ls2's ,cnc ported 243's, comp cam
07-30-2009, 01:18 PM
#1
10 Second Club
Thread Starter
iTrader: (126)
Join Date: Sep 2004
Location: TAMPA
Posts: 594
Likes: 0
Received 0 Likes
on
0 Posts
L@@k complete 6.0 ls2's ,cnc ported 243's, comp cam I purchased these motors for projects that I have already given up on, so they need to go.
2006 Trailblazer SS 6.0 complete drivetrain
I have a complete 2006 TBSS 6.0 LS2 drivetrain out of a 2wd truck that rolled over. It has 18k miles on the whole package. It comes with motor with all accy. still attached, tranny with converter, and wiring harness . It might need 1 coil becauce it got a little caught between the motor and the chain when taken out. It is a complete take out. Slap a car intake ,your oil pan and a cam sensor extension on here and replace your LS1 with a low mileage higher horspower combo.*** $3000 plus shipping. *** SOLD
Then I have a complete 2006 TBSS 6.0 LS2 drivetrain out of a 4wd truck that was rear ended. It has 12K on the motor and has 4k on a replaced by GM transmission. It comes with motor with all accy. still attached, tranny with converter, transfer case, front diff bolted to bottom of the motor and wiring harness . Needs a water pump. It is a complete take out. *** $3500 plus shipping. ***
Pics of the motors should be up by Sunday night.
LS6 CUSTOM PORTED 243 HEADS
These heads are currently on my 6.0 in my sig.They have 2.05/ 1.6 Rev Valves with Patriot Dual springs with Titanium retainers installed. They were ported by M2 Race Systems in New Jersey to Absolute Speed's Spec's. They will be removed this coming up week. The heads have 6 motor passes, (3) 100hp nitrous passes and less than 1000 miles on them.
They Flow 324 Intake and 212 exhaust @ 600 lift but the exhaust flow better with a 1 3/4 pipe on them. I have over $1600 in the head setup.
*** SOLD ***
COMP CAM Camshaft from my motor in my sig. Will be removed in the up coming week. Same useage as my heads from above. Here are the specs:
234/238 595/605 XER lobes on a 115 LSA.
I'm asking $280 shipped.
Vids can be found of my passes on my fquick link below.
I take PAYPAL.
2006 Trailblazer SS 6.0 complete drivetrain
I have a complete 2006 TBSS 6.0 LS2 drivetrain out of a 2wd truck that rolled over. It has 18k miles on the whole package. It comes with motor with all accy. still attached, tranny with converter, and wiring harness . It might need 1 coil becauce it got a little caught between the motor and the chain when taken out. It is a complete take out. Slap a car intake ,your oil pan and a cam sensor extension on here and replace your LS1 with a low mileage higher horspower combo.*** $3000 plus shipping. *** SOLD
Then I have a complete 2006 TBSS 6.0 LS2 drivetrain out of a 4wd truck that was rear ended. It has 12K on the motor and has 4k on a replaced by GM transmission. It comes with motor with all accy. still attached, tranny with converter, transfer case, front diff bolted to bottom of the motor and wiring harness . Needs a water pump. It is a complete take out. *** $3500 plus shipping. ***
Pics of the motors should be up by Sunday night.
LS6 CUSTOM PORTED 243 HEADS
These heads are currently on my 6.0 in my sig.They have 2.05/ 1.6 Rev Valves with Patriot Dual springs with Titanium retainers installed. They were ported by M2 Race Systems in New Jersey to Absolute Speed's Spec's. They will be removed this coming up week. The heads have 6 motor passes, (3) 100hp nitrous passes and less than 1000 miles on them.
They Flow 324 Intake and 212 exhaust @ 600 lift but the exhaust flow better with a 1 3/4 pipe on them. I have over $1600 in the head setup.
*** SOLD ***
COMP CAM Camshaft from my motor in my sig. Will be removed in the up coming week. Same useage as my heads from above. Here are the specs:
234/238 595/605 XER lobes on a 115 LSA.
I'm asking $280 shipped.
Vids can be found of my passes on my fquick link below.
I take PAYPAL.
Last edited by GONEB4U; 08-08-2009 at 08:08 AM.
07-31-2009, 01:57 AM
#6
TECH Fanatic
iTrader: (26)
Join Date: Aug 2008
Location: Where our street cars are faster than your racecars..Mississippi
Posts: 1,113
Likes: 0
Received 0 Likes
on
0 Posts
what about any trades ?
check out my for sale thread 2002 SS part out--aftermarket/oem LOTS OF STUFF
and i also have alot of car audio (around 5k worth i'm bound to have something you like..lol)
pm me lets talk i would like to have the heads
check out my for sale thread 2002 SS part out--aftermarket/oem LOTS OF STUFF
and i also have alot of car audio (around 5k worth i'm bound to have something you like..lol)
pm me lets talk i would like to have the heads
Trending Topics
08-01-2009, 08:11 PM
#12
12 Second Club
iTrader: (13)
Join Date: Feb 2005
Location: Gateway International Raceway
Posts: 1,575
Likes: 0
Received 1 Like
on
1 Post
One of those would be great for my 2000 'Burban... Post some pics. I will have to do some research on the tranny whether or not it will work on truck or not. Good luck and that is a good price on those motors though...should sell quick. Does the CPU come with the motor? I might have to get some credits for HPTuners for my truck to do this swap...
08-04-2009, 05:55 PM
#16
10 Second Club
Thread Starter
iTrader: (126)
Join Date: Sep 2004
Location: TAMPA
Posts: 594
Likes: 0
Received 0 Likes
on
0 Posts
Here are pics of the 4WD setup. Transmission is seperated only for storage reasons.TQ is still on motor. **** SOLD ****
Last edited by GONEB4U; 08-17-2009 at 08:26 PM.
08-09-2009, 04:29 PM
#19
10 Second Club
Thread Starter
iTrader: (126)
Join Date: Sep 2004
Location: TAMPA
Posts: 594
Likes: 0
Received 0 Likes
on
0 Posts
Ok I'm willing to take $2750 plus shipping just for the complete motor with accy. and harness. $750 plus shipping for the transmission with transfer case.
