The heads and cam are Cartek stage 2x ported LS6 heads (243 castings). I bought them from forum member Big Mike about 4 years ago. At that time they had new springs (my memory sucks but I think they are comp 921s). Has Titanium retainers. Valves are 2.02 intake and 1.57 exhaust. They are milled to bump the compression up, and custom length Comp 1 piece pushrods come with the package. I'm not 100% what size the chambers are, but I do remember them telling me my compression would be between 11.2 and 11.3. So I would guess they are around 60cc. I'm switching my setup over to forced induction so I need to lower my compression and can't use these heads anymore.

Cam is Comp Cams XER 230/236 .605/.610 on 113 Cam was custom speced by Cartek for these heads. It really loves nitrous!

Pushrods for this setup are included. They are Comp 1 piece chromemoly.

I put no more than 4k miles on these heads so the springs etc. have very few miles on them.

$1200 for everything. Plus shipping (I get a discount with fedex) and 3% if you use paypal. Local pickup is prefered, but I can ship everything just as well.

Thanks,
Frank

 

Valves are stainless.

 

My car ran 11.2 @ 124 with these. Went 10.2 @120 (let off) on a 200 shot.

 

You need some 72cc chamber/Ported LQ9 heads? Possible trade?

 

Ugh. I did need a set, but I ordered a set of darts and had the chambers opened up. Just installed them last night.

Frank

 

What bottom end? What is the cars weight also?

 

Bottom end is basically a stock 346, but forged. Stock crank, eagle rods, Mahle flat tops. Car is around 3200lbs. I need to put her on a diet

 

Here is a video of the car at idle

http://www.youtube.com/watch?v=s13Xv4r068o

 

What kind of #'s did you get out of this set up?

 

Dang nice setup there

 

Im gonna try to hit my wife up for 200 bucks see if I can pick these up. Im sure she will be just thrilled since I just dropped my eclipse motor off at the machine shop

 

It ran 124mph in the quarter in a 3200lb car. Those are the most important #s of any setup!

Thank you very much! Lots of blood and sweat went into this car and comments like that make it all worth it!

Just hit her up for $100. If your going to drive up from Baltimore and save me from shipping them you can have them for $1100 cash.

Thanks,
Frank

 

will work her in the morning. She already passed out on me.

 

Here's a vid of this heads cam combo with a 200 shot NX fogger. I ran out of gear before the 1000ft mark! Drove it to the track and granny shifted it! Check out where I hit 2nd gear.

http://www.youtube.com/watch?v=Z77mr8IEyyI

 

lightweight Mine's out too!

 

So this will all work on a bascily stock LS1, no fly cutting pistons or anything? Very interested in this set up.

 

Yes, Cartek told me this will work with a stock bottom end without flycuting. But you always want to check when you assemble the engine.

 

wish i had my income taxes

 

PM me best price shipped to 68134, still very interested.

 

That Nova is very sweet!