Category: Audio/Video/Electronics
Price: $1
Location (State): OH
Item Condition: Used

853 casting cylinder heads that were hand ported by Larry lykowski PRC dual springs, Ti retainers, new seats and seals. Sold

Victor Jr intake - Sold

870 APD carb 4150 style - Sold

Hardened pushrods - Sold

ARP headstuds - Sold

Shortblock with stock crank, rods (arp bolts), and pistons front and rear covers included - 300 plus shipping

MS4 camshaft - Sold

LS6 ported oil pump from Thunder Racing - Sold

LS2 timing chain (low miles, done with MS4 swap) - Sold

AED birchwood .5" spacer for 4150 - 20 plus shipping

Yank TH400/LS1 converter 10" 5000 stall - 525 plus shipping

Stock ls1 coil packs and brackets - 100 plus shipping

AED anodized throttle linkage for 4150 - Sold


2 stage NOS plate for 4150 8 holes per bar/ 32 total. $80. You will need to replace one of the fuel side fittings. No biggie, like 4 bucks from N.O.S.



Pacesetter 1 3/4" primary LTs and Y pipe - Sold

 

Bump!!

 

how much for the starter and alternator if you still have them

thx

 

Pics To Little_Dan04@yahoo.com .. Thanks

 

If anyone is interested in just the engine without the carb I would let it go for 2700.

 

Willing to part out the engine now. IF anyone needs anything lemme know.
Ported heads with dual valvesprings
MS4 cam
TCI flexplate
LS6 ported oil pump
LS2 timing chain
Shortblock
Pacesetter headers
ARP head studs

Just ask!

 

best price shipped to 46992

 

do you have a carb intake and msd 6010?

 

Would you sell the valvesprings only?

 

not sure what trans you had but do you have the adapter to run a th350/th400 converter?

 

Live fast, I should have one of the spacers. Although I just purchased a Yank 5000 stall built specifically for the TH400/LS1 setup.

A98WS6 possibly, I'll get you a price tomorrow

71chevelle, yes I do

TABud, I'll PM you a price first thing in the morning when I get to the shop.

Thanks all!

 

pm sent

 

how much for the vic jr intake?

 

How much for the TCI flexplate shipped to 85635? If possible, can you send pics to croppduster@rocketmail.com? Thanks!

 

I also have coilpacks, AED purple anodized throttle bracket, MSD plug wires that I would love to get rid of!

All PMs replied to. Thanks again!

 

what parts do you still have, im interested in headers and y pipe, and cam, would like to possible pic them up soon, asap even tomorrow sometime, send pics of headers, how many miles on cam
thanks bud

 

Still interested in the springs.

 

How much for the long block minus -

timing chain
oil pimp
carb
intake
cam

DM

 

Interested in the 6010 controller and harness if you still have them.

 

The MSD, intake, cam and pushrods have all been sold. I'll get pictures up of everything else asap! Thanks!