Category: Engine - Complete Motors
Price: $0
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): MO
Item Condition: Used
Engine: LS1/LS6

All parts are OBO and are + shipping


Stock LS1 shortblock 117K on it, ran great when I pulled it, however it is due for a rebuild, did smoke a little and had some piston slap. But other than than it ran GREAT. $550

TEA Stg II 317's with comp 918's on them, same as cam approx. 40K on them (was told they were milled .030, can measure to be sure when I pull them off). This h/c ran VERY good on my car, and will not dissapoint. $800

GTP Stg II 853 castings. I don't know the mileage, they look to be in good shape, and have double springs on them. $550

stock ls1 flex plate, I have 2 of these, $40

A4 crossmember, I have 2 of these also $25

A4 pedals $60

LQ4/9 water pump 90K $20

LQ4/9 flexplate w/ crank spacer $30

LQ4/9 coils w/ brackets and harness' $100

LQ4/9 starter worked good to my knowledge $40

5.3 truck manifolds off '06 1500 perfect shape, good for turbo setups. $75

SLP dual dual tips (stainless) in perfect condition $50

SLP dual dual muffler (stainless) with oval slant cut tips $75

have an extra set of cover minus oil pan let me know what you need and we can figure it out.

Wolfe Race Craft 6 Point roll bar, for convertible Powder Coated black it has a couple scratches but in good condition $450 cost well over $600 new w/shipping. will fit LT1 and LS1 verts.

Front calipers w/ mounting brackets and rotors was told 70K on them $50


Please PM me with any questions, and pics can be available if needed.

thanks for looking,

Levi

 

up top

 

updated ttt

 

PM sent on flex plate

 

Pm me your lowest on the truck coils and brackets please! Pics would be good too thank you!

 

pm me how much for lq4 flexplate shipped to 77541. thanks.

 

need a starter for a ls1

 

I'm not sure if a 6.0 starter will work or not honestly. But I know the wire hookups and bolty patern is the same. Not sure if the throw is the same though.