SOLD!!!

I've decided to sell my drag wheel setup.

The rears are 16"x8.5" (not exactly sure on width, could be 9") with 255/50-16 Hoosier Drag Radials (75+% left). The back spacing is 5.5"-6". Fits an F-Body well.

The fronts are 15"x3.5" with like new 165s from Discount Tire.

Here are a few pics of them on my TA.









I will include lug-nuts and center caps. Wheels have been mounted on a Mustang before so the alternate set of lug holes show washer marks. A $5 set of plastic plugs would hide these marks and look great. The wheels are dirty and could use some polishing but are in good shape.

The 255 Hoosier tire is as wide as a 275 in a 15" tire (10.5") so these hook well on the street. My car makes 475/475 and I had no problem hooking from a dig. They usually will not spin on motor only. The one time these have been to the track, I went 11.3x @ 122mph with a 1.7x 60ft. This was taking it easy. I believe these would go 1.5x 60fts.

Price is $650 obo.

Worthwhile trades will be considered.

I will split to sell rears only, but not just the fronts.

 

What would you bee looking for in trades?

 

Looking for: 9" housing, aftermarket torque arm, subframe connectors, tubular upper/lower a-arms, drag shocks/springs, stand alone fuel system, roll cage, aftermarket seats...

 

pm sent

 

Replied.

 

Lots of interest, but no money yet...

 

did you have to use any spacers? I was told that the backspacing for fbodys was 7.5in. I may have a spohn pro-series tq arm with cross member ds saftey loop that I might be taking out of my here very soon. Not sure if it will fit your car since it was made for a dana s60 though

 

The backspacing for a 10" wide wheel to mount correctly is 7.5". The backspacing for a 8" wide wheel to mount correctly is 5.5". These are somewhere around the 5.5" as they are around 8-9". They look great on my T/A.

If your torque arm would fit a stock 10-bolt and a Moser 9" rear, I'd be very interested. See if you can find out or give me the part # and I'll check. Thanks.

 

this is the very same one I have with the del-sphere pivot joint in black

http://www.spohn.net/shop/1998-2002-...rs-Y-Pipe.html

 

I'm sure that torque arm would work for me and I'd be interested in some sort of swap. PM me and let me know what you'd like to do on it....

BUMP!

 

pm sent

 

Bump! Remember, I am open to trades!

 

How Much for just the back wheels & tires.

 

What are you looking for? I have some assembled 317s I would trade toward those plus cash.

 

PM sent. Would only be interested if they were ported or aftermarket heads. Thanks anyway!

 

how far are you from dallas? trade for grey zr1s 9.5 all around

 

I am actually in McKinney which is 30miles north of Dallas. Not looking for any other wheels unless they're drag style....

 

Wednesday Bump. New Price: $625

 

Okay going out on a limb here.. would you be willing to trade for an old school honda Big Red 3 wheeler?

 

If I weren't trying to upgrade my car a little, I would be all over that... Big Reds are sweet! I've rolled many-a three wheeler in my day! Thank you for the offer, but I better skip this time...