Category: Audio/Video/Electronics
Price: $999999
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, 04-06 Pontiac GTO, 04+ Cadillac CTS-V
Location (State): IN
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9, LS1/LS6
LS Engine?: Fits LS Engine

I have a few things that I have taken off my SS, cause I am turning it back into a street car, and building a race only car.

Got lots of random stuff so here goes a quick rundown. items that are priced shipped, are marked shipped.

First off.

-Set of qa1 "R" series drag front shocks, with matching 275lb springs. I ran these with a Iron block without any problems, had a lot of stored energy to help the car launch. single adjustable. I also have the matching rears that are single adjustable, along with eibach drag launch springs. I am looking to sell together and make a deal to someone. only thing missing from the shocks are the front strut mounts, everything else to install is included. I bought this setup new, and been raced for roughly 2 seasons. no problems, no leaks, worked rather well. down mind the little bit of black on one of the rear shocks, its just from the cars exhaust and when I touch up painted my rear end... nothing more.

Asking SOLD for the whole setup



-Got a Harris Speedworks sudden impact single nozzle wet kit for sale. I used a whole 5 bottle's of nitrous through this kit, I always used nitrous filters(wont be included in the kit). will come with mostly complete wiring, very few cuts(only cut where splices where made) to remove from car, will also come with a harris speedworks bottle heater kit and a purge kit. also comes with a digital msd window switch.

Looking to get $300 bucks for everything, and if you have a f body, I got a spare tire bottle mount kit and a console nitrous outlet nitrous control panel that mounts in the ash tray. throw in both of those for $50 bucks more. and if your want the remote bottle opener with wiring harness to plug straight into the ash tray panel, I'll throw that in for $50 bucks more. so $425 bucks shipped for every nitrous thing off my car... ONLY thing I cant find is the org bottle that came with the kit. Let someone use it, forgot about it and now I really dont know where its at.






have more pics of a few things, just getting late outside.

Up next is a 3 pillar gauge pod, will also include the full pillar pod with a auto meter water temp gauge, short sweep Ultra Lite II series electrical. and the modded stock a pillar cover(holes cut for wires to come through) also matches where the screw locations are for the pillar cover. sell all together for sold bucks shipped. It is for a T-Top car.



Got a set of Trans am Leather seats out of a 02 model that had 42k miles, very good shape and will come with trans am seat rails, power drivers. I do not have the pump harness or the pump lines, bit the pump is in the seat if needed. I didnt even wipe them off yet, so dont be picky about the pics, they are very very nice. rather show you what they look like before I shine them up... Looking for $350 picked up. willing to meet within reason. PM with any questions.


Got a set of Drag lites for sale. 15x8 and 15x3.5 the rears are 5.5 bs. I know everyone runs 15x10, but I found that these fit a little better on a camaro to run a set of 28x10.5 MT's, without BFH'in the inner fenders, and would clear the outside lip fine if my car didnt sit so low. They polish out very nice, NO TIRES WITH BE INCLUDED!! it will be the 4 rims, with screws for the rears. Looking for get SOLD for the whole setup pick up or willing to meet.

I will get more close up of rims tomorrow.

 

Pm sent.Dibs on Spare Tire Mount & Ash Tray Switch.Maybe Bottle opener

 

Pm on Seats

 

You have a PM

 

I got dibs on the A pillar gauge pod if nobody has already. Paypal ready. PM Sent.

 

pending sale on the gauge pod. got to get lots of shipping quotes, and its kinda hard to do that from work.... haha

 

How much for the rims shipped , would you do 400 shipped?

 

400 shipped is a little low, I think shipping is around 25 a wheel, so I could split with someone. wanting a shipping quote also?

 

you got a pm.

 

send me a pm , i wanna talk .

 

and do the fronts fit without gringding ? lemme know , i wanna text you .

 

I got matching spacers to use with the fronts to clear stock brakes without grinding. I grinded the rears to fit without a spacer.

and lets change the prices on the nitrous stuff i got. its all sitting on my garage floor taking up a lot of space. so lets do

$450 shipped on everything nitrous I have listed!! I would like to sell as a complete kit. in a few days I will start parting it out.

thanks. and if I missed anyones PM's, hit me up again. I was busy last night getting shipping quotes and might have missed a few.

 

pending payment on the wheels.

pending sale on shocks.

gauge pod and water temp gauge sold

 

send you a pm on the shocks

 

wheels sold,

qa1's sold.

thanks guys.

TA seats still for sale.

and I would like to just sell all this nitrous stuff together. I will sell everything together for $400 shipped!

 

still got the trans am seats, and the nitrous stuff.

 

Still waiting on the 3 Parts Im ready to pay for.Just need paypal info

 

If you decide to part the Nitrous kit I may be interested in the window switch and possibly the heater. Let me know if you decide to separate?

 

Whats the deal with this? I havent heard a word back.Just waiting on Paypal info to send the money.......

 

parting out the kit, sending PM's.