241's, 853's, Cams, Pushrods, Intake
Thread Starter
TECH Resident
iTrader: (60)
Joined: Dec 2006
Posts: 849
Likes: 0
From: Jacksonville, Florida
241's, 853's, Cams, Pushrods, Intake Category: Engine - Power Adders
Price: $325
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette
Location (State): FL
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS1/LS6
LS Engine?: Fits LS Engine
Thunder racing pushrod 7.400 1k miles - SOLD
Factory 241 heads milled .030-.035 with patriot dual gold springs, titanium retainers, stage 8 locks $450.00 obo they have 1k miles since been refreshed
Factory 853 Heads - 155k miles complete just pulled off motor. Will need rebuilt - $75obo
1999 Stock cam - 155k miles - $75 obo
1999 Stock Pushrods 155k miles- $35 obo
1999 Stock LS1 Intake - SOLD
1999 Stock Throttle Body - $40 shipped
ls7 Lifters - 50 miles - Look brand new currently soaking in oil because was going to install with H/C swap but found out motor was bad. SOLD
Only reason for selling is going alot bigger and need $$$. Please PM me if i don't respond.
Last edited by Choppers; Jun 22, 2011 at 10:10 AM.
Thread Starter
TECH Resident
iTrader: (60)
Joined: Dec 2006
Posts: 849
Likes: 0
From: Jacksonville, Florida
Trending Topics
Teching In
Joined: Apr 2010
Posts: 9
Likes: 0
From: Gainesville, Ga
241 compression ratio I'm sure I could probably search and figure it out. But since they are your heads, you might know. What is the compression ratio on the 241's that are milled .030 - . 035 on a stock motor?
Thread Starter
TECH Resident
iTrader: (60)
Joined: Dec 2006
Posts: 849
Likes: 0
From: Jacksonville, Florida
Pics of the 853 heads to elemr86@gmail.com. Thanks
Thread Starter
TECH Resident
iTrader: (60)
Joined: Dec 2006
Posts: 849
Likes: 0
From: Jacksonville, Florida
Not sure because I bought them from my buddy Sean and his car was very stout. You can post up in the ls1 internal section and somebody might answer. Shipping would be about $50 as well.
