I have a set of slighty used (maybe 4,000 miles) carrillo rods that came out of a iron block ls1 motor, they are 6.125" in length, .927 wrist pin, 2.100 crank pin, and they have the 7/16 carr rod bolts(285,000 lb from what I can remember, torque around 90 ft lbs). I will have some pics of them up shortly. These rods are not ls1 specific origionally designed for a sbc but they work fine with ls1 set-ups and barely offset on the piston pin. They go new on several sites for $1800 and I am asking $900 shipped or best offer.








Post edited to shorten it

 

Check PM

 

I want the cam.... $150? PM ME!!

 

Pics of the rods?

 

I will try to get pics up a.s.a.p..

 

cam and rods still available, will trade rods for a set of high end ls1 specific rods like oliver or lunati billets plus alittle cash possibly.

 

Do you have to fly cut pistons for that cam?

 

rough cam pictures...cant read it too well

 

Cam sold, rods remaining will even or plus cash for a set of high end ls1 specific rods.

Anthony

 

What weight are these rods? What was the part#

Nate

 

I can have them measured, but never have thought to up untill now. They are the barely offset sbc rods. I didnt buy them new so I dont have a part number either. Anything else?

 

To the top please

 

again to the top