Trick Flow 7.350" pushrods. Perfect for milled heads. I have 2 sets. Both sets installed in stand motors, but never run. Basically new. $65 shipped each.

 

I just bought some 853 heads and there milled .005 and i want to go another .010, will these work for my app.?

 

Yes, they'll work for your app.

 

What about on a stock head?

 

I have heads milled .010 and I am switching to a .581 cam from stock. You guys think these will work?

 

Stock PR's are fine for stock heads or an upgrade to a chromoly stock legnth replacement.

The smaller base circle of the new camshaft will offset your .010" milling. Stock legnth rods will be fine for your application as well. It's when you start going .020" and over on the milling that you need to start looking into these.

 

I'll take a set, pm me your paypal address

 

Both sets sold to V8 and Ken.