99FormulaWs6

Thanks to the beautiful weather, I've been able to drive my car the last two days, and that ugly *** side molding has just been too much to look at. So rather than trying to "slice" with fishing wire, I simply took a pair of vise grips, pinched the moulding and pulled straight off. Now this didn't make pealing the glue off any easier. My fingers are sore...when the blisters go away, I'll get some pictures. But it looks MUCH better.

SVThis

iTrader: (2)

ummm...shoud have used wd-40 or some sticker remover to loosen everything up...thats what i did on my 98...made the job EASY

black97ss

iTrader: (6)

heat gun if you dont have a heat gun use a hair dryer, thats my personal preferance, then the glue comes off easier too

mrws6speed

Hair dryer was what I used. !SideMolding is one of the best mods IMHO!!!

Ell Ess Won

yep, killed mine quick. and my thumb had huge (1/4") blisters full of liquid.

OneMeanZ

iTrader: (2)

Best thing I've done to my car.

01bird58

iTrader: (9)

side molding mod best free mod ever I used hot water

~JOSHUA

iTrader: (92)

I'd do it, but the Firehawk decal on the door looks out of place without the moldings on to "frame" it.

I've seen !molding Firehawk photos.

Firehawks need the molding.

99FormulaWs6

I used a hair dryer, but it didn't make that much difference, other than getting it started.

kyles2000z

iTrader: (8)

use hair drier and WEAR GLOVES PEOPLE. dang, everybody complaining about blisters and no one thinks to just put pair of mechanics gloves on or somethin. i had no blisters, an not even any soreness. but definately the best free appearance mod you can do.

slim0035

iTrader: (2)

It made mine look better. My Ram Air stickers were starting to peel so I pulled them off with the idea of putting more on but I liked the look. It makes the WS6 hod flow a little better IMO.

nhra-trans-am

iTrader: (103)

Agreed

huskerpower02

Lets see some PICS!

Phoenix 5.7

iTrader: (7)

I had my side mouldings removed when the car was at the body shop. made a world of difference in looks. then the Trans Am lettering looked out of place, so away that went too. i love the smoothness of the side now. Im even debating removing the WS6 badge to clean it up more.

01Generalee

iTrader: (1)

yuh I did that mod. Its a good one I did the !Emblems to

BTTM

iTrader: (1)

Brain freeze. I trying to picture what it would look like without the molding. Can anyone post pics, pleeeeese!

00'WS6Rocket

iTrader: (3)

same here i wanna see pics

Phoenix 5.7

iTrader: (7)

im lazy right now, but i have some pics of my car without mouldings in the gallery the site in my sig

NxLS1496

iTrader: (1)

i want to remove mine but im worried that the sun might have faded the outside paint and that itll leave an imprint of where the molding was, anyone have this problem?

nhra-trans-am

iTrader: (103)

with trans am emblem

Without