Thought I'd share some pics after I got all of this stuff done. I deleted the rear seats, added a Wolffe 5 point bar, Corbeau racing seats, 6 point harness, the leather boots and the Momo steering wheel. The boots are leather from Redlinegoods. Pics are nothing fancy. It was threatening to rain so stayed in the driveway. Enjoy.

 

got more pics of the rear seat delete ??

 

I like that wheel!! Where are the attachment points on a "5 point" roll bar? I know where they're at on a 6 pt.

Bryan
parbreak

 

Yes. I'll post them up a little later.

 

Thanks. The 5 point is the same as the 6 but without the passenger door bar. I don't need it to race and it lets passengers get in and out much easier (and saves weight).

 

Here are the best pics I have--taken in the garage in the middle of last winter. This was before the racing seats. Since the new seats don't fold, you can't really get a good pic back there. Anyway, I wanted to keep it light so I covered two pieces of 1/4 inch plywood with vinyl and bolted them in place at the seat attach points. Then I tacked a small strip of carpet along the front edge. That way I can stash small obeject under there where people can see them.

Also included one more pic of the Momo wheel.

 

really diggin the rear seat delete

 

I was a little skeptical about the steering wheel at first, but I actually like it a lot! Everything looks great.

 

nice and tidy i like

 

looking good!

 

I have a momo as well. Bye bye air bag, but who cares. It looks cool and is much smaller than the ugly stocker.

 

That's a pretty slick setup. Looks nice.

 

where'd you get the wheel and what di dyou ahve to do to get it in? looks great btw!

 

Thanks for the compliments everyone.

I bought the Momo wheel from a web site. Just did a search on Momo. I was a little skeptical at first too, but it grew on me. I like the small red accents that go well with the interior lighting. I followed that them with the boots, harness, etc.

The wheel was a pain to install--not really that hard, but harder than it should have been. You have to pull out the airbag stuff, trim the column about a sixteenth of an inch, work over the adapter with a dremmel tool, figure out how to make your horn work and bolt it on. But it was worth it to me since I didn't like the factory wheel and can live without an airbag (I know some can't). I liked the steering wheel controls but get along fine without them.

If anyone wants more detail, post up or send a PM--glad to help. Thanks again.

 

What seat model is that the Forza?

 

No, it's the FX1. I'm 6'4" and 210 lbs. I wanted a fiberglass shell and this was one of the very few fiberglass seats that I'd fit into.

 

"I didn't like the factory wheel and can live without an airbag (I know some can't)."

Hey - I don't see so good - is that Wolverine?? I know he can live without an airbag.
;-) just messin

Looks really good with the minor red accents on the wheel and boot etc. and you get extra points for adjusting your vents the same positions that I do (thumbs up)

 

Props on the rear seat delete! Nice package you have there, I also dig those seats.

 

I would LOVE a write up on how to get the wheel to work. I am gonna do a nice grant wheel some time soon.

 

Those rear seat deletes look great!