Hey everyone,

I have a set of heads a porter here in cali ported. His name is Brad Lagman and the flow numbers on the heads were 292 cfm @ 600 lift. I no longer have the flow sheet.

These are 5.3 #862 truck heads that have been shaved .30

With a 229/.578 cam I made 430 rwhp, with a nitrous tune, on a 6 speed stock rearend car.

The heads are good, but are straight off the car and a little dirty. They have Isky 295D springs and retainers with about 20K miles on them. The heads have 2.02/1.60 stainless SI valves.

The reason I am getting rid of them is because I went forced induction and I bought a set of stock 317 heads for the turbo setup.

They have been sitting around for 6 months, PM if interested. The price is negotiable, make me an offer.

Glenn

 

could i get some pics to viper9403@aol.com? and what are the springs rated at?

 

Let me see if I can find some pics, if not I have to get a new cable for my digital camera so I can send some to you.

Glenn

 

I'm interested in pics too, please.
shraderbj@sbcglobal.net
Thanks,
BJ

 

and would these fit on a 98 camaro?

 

yeah they would

 

yes they would, I will have pictures by Sunday. I will send them out as soon as I get them.

Glenn

 

Just paid 750 for a set with similar flow #'s! GOOD DEAL! wish I would have seen these!

 

I really wanted to try and re-use these heads. However at 11 to 1 is just not boost friendly. So I bought used truck heads, cleaned them up, installed new valve springs and that cost me 850

Anyways,

Glenn

 

ill take pics when you get them @ nicksutterer@sbcglobal.net

 

what cc are the chambers or do you know what kinda compression ratio the will get me on an 5.3. if it will get me higher than say 10.5, and you will take 450 shipped to 76033 consider them sold.

thanks
Jon

 

Pictures sent