Well not quite one of the rails themselves, but rather where the scrader valve is on the pipe on the back. I had to pull the sender unit for the electric fuel pressure gauge I installed back off to pull the schrader valve out, yeah well it bent it and it cracked.
I did manage to find someone who would finally weld it, yeah it still leaks, but its a lot less than it was. So tommarow I am going to try to JB Weld up the last little hole. If this dosen't work anyone have a spare fuel rail laying around?

Go figure, every single part on the fuel rail is replaceable, except for that one part, you have to order the whole right side of the rail to get that back tube that the schrader valve is attached to.

 

dude i would not even attempt to jb weld that spot it is far too dangerous i have the parts you need 30.00 shipped
oh BTW its a complete rail w/factory regulator

 

^sent pm.

 

cool gotcha back!

 

IF that falls through i also have a spare fuel rail
I will do it for the same price.
whointhehellami@yahoo.com
not trying to steal your sale just a backup