FS: cam, heads, ported Vic jr, morel lifters
11-26-2006, 07:24 PM
#1
10 Second Club
Thread Starter
iTrader: (14)
Join Date: Mar 2002
Location: Kansas City, KS
Posts: 2,893
Likes: 0
Received 0 Likes
on
0 Posts
FS: cam, heads, morel lifters $300 - FTI spec'd hydraulic cam. very little use, maybe 10 miles and a few passes
The power band is “roughly” between 4200 to 7600 rpm for 402-410 cubic inches.
Gross Valve Lift 1.70 Ratio: .671” .671”
Duration @ .050”: 244* 254*
Lobe Separation: 110*
Recommended Intake Centerline: 107*
$125 7.225 pushrods, .115 thick walls
$400 morel lifters, barely used, brand new condition
$900 5.7L heads, 2.08/1.60 brand new springs and valves. made 552rwhp on my 408. springs have over #400lbs open and over 170 closed and are good to about 680 lift. 62cc chambers, pockets cut for 1.46" springs.
flow, I/E
.100 70/51
.200 150/110
.300 217/154
.400 264/197
.500 291/222
.600 304/233
.650 310/
you will have a hard time finding a stock casting head that flows as well as these at MID-LIFT
The power band is “roughly” between 4200 to 7600 rpm for 402-410 cubic inches.
Gross Valve Lift 1.70 Ratio: .671” .671”
Duration @ .050”: 244* 254*
Lobe Separation: 110*
Recommended Intake Centerline: 107*
$125 7.225 pushrods, .115 thick walls
$400 morel lifters, barely used, brand new condition
$900 5.7L heads, 2.08/1.60 brand new springs and valves. made 552rwhp on my 408. springs have over #400lbs open and over 170 closed and are good to about 680 lift. 62cc chambers, pockets cut for 1.46" springs.
flow, I/E
.100 70/51
.200 150/110
.300 217/154
.400 264/197
.500 291/222
.600 304/233
.650 310/
you will have a hard time finding a stock casting head that flows as well as these at MID-LIFT
Last edited by 383ss; 12-10-2006 at 09:26 AM.
Trending Topics
11-29-2006, 05:54 PM
#10
10 Second Club
Thread Starter
iTrader: (14)
Join Date: Mar 2002
Location: Kansas City, KS
Posts: 2,893
Likes: 0
Received 0 Likes
on
0 Posts
www.cylinderheadspecialties.com a guy in Wichita, KS. very good guy, he's just not an 'internet' guy.