97 WS6 4 sale 9K OBO
#1
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Dec 2005
Location: ORANGECOUNTY
Posts: 1,005
Likes: 0
Received 0 Likes
on
0 Posts
97 WS6 - LT4 Firehawk clone
my cars for sale, 97 ws6, real ws6 - NOT a clone, 103k miles, od is off, 3:73's were put in almost 2 years ago and the od wasnt recalibrated, so it reads 108.
asking 9 grand obo, located in temecula, i will tow as far east as missourri to deliver
heres a mod list -
Performance mods -
PCM for Less tune
LT4 Intake
SLP Shorty headers
LT4 heads
Throttle Body bypass
LT4 knock module
Manual electric fans
SLP Strut Tower brace
K&N Air & Oil filter
160* thermostat
Air foil
Tranny cooler
1.6 RR's
3200 Stall Converter
Oil Cooler
02 Simulators
Exhaust Cutout
Zexal Firehawk carrier
3:73 gears
Magnaflow exhaust
Kuhmo Ecsta Supra tires
Accessories -
Hurst Line Lock
Piller pod - Tranny temp and Oil temp gauge
pioneer system with Q-logic custom sub box
Drivetrain safety loop (not really accessory, but I didn't know where else to list it)
Viper alarm
Exterior mods -
Blue headlights
Euro-Dezigns Xenon blue foglights
Navy blue metalic decals
Clear corner markers
Clear rear bumper markers
Gloss black painted calipers w/silver Trans Am decal
White filler panel overlay
Blue WS6 badge
heres the info on the cam, it has the correct dowel pina dn its ready to go in, it made almost 500 h/p in a 383 -
Duration @ 0.050" Lift : 222/230
Valve Lift : .509"/.528"
Lobe Seperation Angle (LSA) : 112
RPM Range : 2000-5500
Camshaft Type : Hydraulic Roller
i have TWO pcms, one has the tune, one is stock, and used for emissions. ive never had a prob passing, the tuned pcm makes the car run a bit lean. car has clean carfax, very well takin care of, no wrecks. tan interior, automatic, pass rear corner marker is cracked, i think the screw was to tight and over time it caused stress cracks, i *think* i have the stock yellow markers for the front. car runs great, awesome shift kit, shifts at 5800 rpm. everything works fine, the drivers headlight gear needs replaced, it works fine, just makes noise. top end seals replaced a couple years ago when it had an lt4 hotcam put in, dynoed, tears of sadness and the stock one put back in. the clear coat is missing under the stripe on the hood, long story, guy wont pay to fix. wear on drivers seat, tear in pass, qouted $100 to fix. backseat is awesome. **HAS** system, pioneer cd player, will more than likely not go with the car, it was 1400$..... and a orion subs with q logic custom sub box, undecided if theyll go. if i can think of anything else ill add it...
***** this car is an LT4 Firehawk clone with a bigger cam*******
selling or trade for pewter ws6
hers pics, i have tons so if you want something specific ask.
asking 9 grand obo, located in temecula, i will tow as far east as missourri to deliver
heres a mod list -
Performance mods -
PCM for Less tune
LT4 Intake
SLP Shorty headers
LT4 heads
Throttle Body bypass
LT4 knock module
Manual electric fans
SLP Strut Tower brace
K&N Air & Oil filter
160* thermostat
Air foil
Tranny cooler
1.6 RR's
3200 Stall Converter
Oil Cooler
02 Simulators
Exhaust Cutout
Zexal Firehawk carrier
3:73 gears
Magnaflow exhaust
Kuhmo Ecsta Supra tires
Accessories -
Hurst Line Lock
Piller pod - Tranny temp and Oil temp gauge
pioneer system with Q-logic custom sub box
Drivetrain safety loop (not really accessory, but I didn't know where else to list it)
Viper alarm
Exterior mods -
Blue headlights
Euro-Dezigns Xenon blue foglights
Navy blue metalic decals
Clear corner markers
Clear rear bumper markers
Gloss black painted calipers w/silver Trans Am decal
White filler panel overlay
Blue WS6 badge
heres the info on the cam, it has the correct dowel pina dn its ready to go in, it made almost 500 h/p in a 383 -
Duration @ 0.050" Lift : 222/230
Valve Lift : .509"/.528"
Lobe Seperation Angle (LSA) : 112
RPM Range : 2000-5500
Camshaft Type : Hydraulic Roller
i have TWO pcms, one has the tune, one is stock, and used for emissions. ive never had a prob passing, the tuned pcm makes the car run a bit lean. car has clean carfax, very well takin care of, no wrecks. tan interior, automatic, pass rear corner marker is cracked, i think the screw was to tight and over time it caused stress cracks, i *think* i have the stock yellow markers for the front. car runs great, awesome shift kit, shifts at 5800 rpm. everything works fine, the drivers headlight gear needs replaced, it works fine, just makes noise. top end seals replaced a couple years ago when it had an lt4 hotcam put in, dynoed, tears of sadness and the stock one put back in. the clear coat is missing under the stripe on the hood, long story, guy wont pay to fix. wear on drivers seat, tear in pass, qouted $100 to fix. backseat is awesome. **HAS** system, pioneer cd player, will more than likely not go with the car, it was 1400$..... and a orion subs with q logic custom sub box, undecided if theyll go. if i can think of anything else ill add it...
***** this car is an LT4 Firehawk clone with a bigger cam*******
selling or trade for pewter ws6
hers pics, i have tons so if you want something specific ask.
Last edited by brynnda; 08-23-2007 at 08:05 PM. Reason: need better title
#4
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Dec 2005
Location: ORANGECOUNTY
Posts: 1,005
Likes: 0
Received 0 Likes
on
0 Posts
97 WS6 4 sale 10K OBO cammed/stalled - highly modded
willing to change the taupe interior over to black, i guess some people dont like it?
Last edited by brynnda; 02-04-2007 at 09:43 PM.
Trending Topics
#15
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Dec 2005
Location: ORANGECOUNTY
Posts: 1,005
Likes: 0
Received 0 Likes
on
0 Posts
97 WS6 4 sale 10K OBO cammed/stalled - highly modded
thanx cutie! i cant beleive its not sold yet, its been on here for almost a year
Last edited by brynnda; 02-04-2007 at 09:44 PM.
#16
TECH Fanatic
Thread Starter
iTrader: (5)
Join Date: Dec 2005
Location: ORANGECOUNTY
Posts: 1,005
Likes: 0
Received 0 Likes
on
0 Posts
97 WS6 4 sale 10K OBO cammed/stalled - highly modded
needs to go desperatley, price is negotiable, i need to pay off my 00 dakota
Last edited by brynnda; 02-04-2007 at 09:46 PM.