a friend is buying my beater ... and i have a few other things about to sell.... all in all i should have 1300-1500 to spend on the new motor/bird in general....what do u guys think i should buy??? i allready have lts, true duals beign made,intake..... so what else? im getting new plugs n wires first too

 

If it's an A4, start with a torque converter and go from there. Or go to vegas and get two hookers at once.

 

I have a Fuddle 3200 stall new in the box I would give you a good deal on

 

how much is a good deal??

 

laughing gas.

 

I 2nd laughing gas

 

Two chicks at the same time, man.

 

I have been thinking $400 shipped.

If I remember right they are like $500 plus shipping.

 

Stock in Wal-Mart?

 

nitrous
or cam

 

Cam
Then torque converter
Then juice it.

 

that almost enough for h/c package... ;]

 

Yeah, but then you'd need at least that much again for the install and supporting components.

 

think im gunna juice it

 

I'd get a stall and then juice.

 

yeah... lt1s can handle 159 wet shot no problem right?

 

also i got offered this

-custom grind cam (226/234 .568 lift with 1.6rr 110LSA)
-new beehive(good to .600 lift) springs with all accompanying hardware(upper/lower retainers and locks)
k-motion k800 springs w/ titanium retainers(good to .700 lift)
should i take any of that?? its trade for my old motor

 

Two chicks at the same time and laughing gas at the same time...

 

I say do the cam...and give me that 3.4

 

i bet u do haha... i dunno is that cam going to go well with a 150 wet shot??...