This started out as a Phamspeed full stainless tubular header kit. It was going in a foxbody mustang, so the crossover was modified (all stainless) to go over the k-member instead of under it like the kit originally had it. To be complete, it needs 5 welds. It was built around an AJE k-member.


Perfect for a foxbody ls1 swap or an f-body that wants the ground clearance over the original version of the kit.


Here is it on the aje foxbody k-member:




Looking to get what I paid for it... 650$ plus shipping.

 

pics in the foxbody would be nice? if it works, I'll take it....

 

The car is off for paint, hence the reason for selling the kit ($$$ paint job). The kit is built around an aje k-member. It works, I guarantee. The mods are just tcked at the moment and need to be fully welded.

 

count me in line!
i'm assuming that the turbo will fit between the pulley and rad?

 

and any idea if it will fit a 4.6 AJE k-member?

 

This is tentatively sold. Ill start making a list though if it falls through. 1dirtyz you are next in line. Yes this kit fits in front of the engine between the rad. There is plenty of room, it was made to fit an f-body engine bay after all...