Have a set of dished Mahle pistons (-26cc, 3.905" bore) for sale, including rings and pins. Asking $350 + shipping.

 

are they brand new never installed?

 

No, they were installed by the previous owner, but he said the engine they were in was "run, but no mileage on them". I purchased them from him, but changed my plans for a new motor and required a larger bore so they've just sat in a box.

 

They're for LS1 stock stroke crank & rod length, yes?
Nice floor BTW.
mv

 

Haha, thanks...I cleaned it just for the photo. I'm not sure of the answer to your question...I would contact Mahle to find out.

 

How much nitrous can they handle?

 

Not sure...I don't have nitrous, nor did the previous owner.

 

Still for sale!

 

Do you have a part number??

 

LS1105905I26 is part number.

 

Im pretty sure these are FI pistons

The -26cc tells me that!

PM sent!

 

All PMs returned!

 

Those are not stock rod length, FYI, and I believe the require a the block to be bored .010 or .005 over... Not sure about the bore. Looks like these are ideal for a turbo set up. Anyone think I'm wrong about any of this? If I am, plz correct my statements! Thanks! I was hoping these were just flycut 4cc stock rod length pistons when i saw the title! Dang it!

 

To my knowledge, they will fit a stock LS1/LS6 bore, but you would have to check with Mahle on that as well as your question about stroke. They are dished, so indeed would be great to lower compression for an FI setup.

 

I did a search for this part # LS1105905I26 and found the following:

Bore 3.905
Stroke 4.00
Rod 6.125
Comp. Height 1.105
Dome Volume -26
CR w/64cc 8.8

I think this would be somewhere in the neighbor hood of a 383.

I hope this helps.

-Dave

 

Thanks! They're still for sale!

 

Still available!

 

Sold!