1982-2002 F-Body cars running a TH400 short tail transmission

Spohn Driveshaft: TH400 short tail (4") $290 Shipped!!! SOLD!
Constructed of 3" o.d. x .083" wall DOM 4130 chrome moly tubing
Extreme Duty Spicer 1350 weld yokes, properly phased and installed in specially built fixtures (total indicated run-out of less than .008")
Extreme Duty Spicer self lubricating u-joints
Extreme-Duty Spicer 1350 series transmission slip yoke
Meticulously welded for maximum strength
Fully assembled and then precision electronically balanced
Ready to install




Cooler Lines: $110 Shipped!!!
* (2) 7 foot #6an steel braided lines
* Includes fittings
* I used this on my M6>TH400 conversion


TCI Cast Aluminum Transmission Pan $100 shipped!!! SOLD!!!
Part# 228000

* GM TH-400
* 2 Extra Quart Capacity
* Includes drain plug and filter extension
* Drilled and tapped for temp. sensor

Madman & Co Transmission Swap Dipstick Tube $35 obo SOLD!!!

* NHRA required locking cap
TH400 into 1993-2002 F-Body

Buyer is responsible for all shipping costs.

Thanks for looking,

Jason

 

Sale pending on tranny pan and dipstick.

 

will that driveshaft fit a short shaft th-400 to a moser 12 bolt. If it will... consider it sold

 

Yes it will. My TH400 setup was exactly that, short tail into a 12 bolt.

 

pm sent on driveshaft!!!!!!

 

I still have these cooler lines.


Everything else is gone. Thanks fellas.