Bo White ported 5.3L Heads
2.02 intake/stock exhaust valves, milled apporx .030, Comp cams 918s blue stripe.
SOLD

Patrick G torque cam
224/228, .643/.648, 110. Has approx 500 miles, great cam with awesome low end.
SOLD

TNT F1 kit
Kit comes with 10lb bottle, 78mm ring, FPSS, MSD window switch, ash tray switch panel, nitrous gauge mounted on bottle, bottle mount for in between rear seats, and NOS purge kit.
$600 shipped

SLP Flow Pack
Good condition, comes with lid, K&N filter, and cold air intake. Lid is trimmed for the TNT kit.
$125 shipped

Yank SS4000 2.6
Just went through by Pats Converters in Philly. They cut it open, flushed out the metal shavings and replaced the bearings. They said that the clutch looked like new so there was no need to replace it. No miles since done.
$575 shipped

Fuddle 3600 2.2
Good converter for a bolt on car, worked flawlessly. Has under 2000mi on it.
SOLD

Genuine Gm 3.73s
Brand new in box, these are genuine gm gears packaged by motive, I have a master install kit, and the spacer for a 2.73 rear end car.
SOLD

TA rear end girdle
Never installed on the car.
$115 shipped

Pacesetter headers
Ceramic coated, they look brand new except for a little surface rust on the bottom of the collector, approx 8000mi
SOLD

True duals w/ single chambers
Custom duals, that fit great and sound amazing. It is 3 in into an H pipe then dumps before the axle, the whole exhaust is painted hi temp black
SOLD

Svo 30# injectors
$250 shipped

Autometer Z series H2O gauge
Never installed
$30 shipped

PICS HERE

 

Take a stock retainer and one of the Comp retainers and it will be obvious on the weight and also the titanium wont rust were the stockers will. I havent milled that much off a set of 5.3s before, most were .018-.020" so they probably have been cut once since I had em. Any dyno #s of your combo?

 

what tranny are the verters for?

 

Never got it on the dyno, but the car ran great, even for me tuning it.

Superado- The converters are for a 4L60E, sorry

 

You got PM

 

To the top

 

Is the Fuddle 3600 2.2 a single or multi disk?

 

I'll take the TA Cover assuming its for a 10 bolt. I have perfect feedback on Camaroz28.com with this name and Bersaglieri305 on ebay.

-Dustin-

 

PM sent on cam. Thanks

 

put a magnet on the retainer if it sticks it's steel if not titanium

 

you still have the comp 918's? send me over the pics to bes383@aol.com so i can take a look at them before i buy.

also, do you know the miles on these?

thanks
Charlie

 

still have the 918's?

 

Yes I do, I've had some interest but no money yet.

 

any e.t with your combo???

 

ran 12.3 @ 111, on a non prep day, with 2.73s and bald street tires. But I was pretty happy with the way it was running.

 

was that cam in a 346? did you have to flycut?

 

Yes, it was in a stock short block,, and I did not have to flycut.

 

Still got the Fuddle? If so please e-mail me at madelisle@yahoo.com Thanks!

 

so would u take 150 shipped for the 918's

 

Bump up