LT1 Edelbrock Intake manifold
Thread Starter
Joined: Oct 2005
Posts: 1,687
Likes: 0
From: Fairfax, Virginia
LT1 Edelbrock Intake manifold + MORE This is Edelbrock's new RPM Air-gap LT1 intake manifold. It was put on the car then taken right back off. Never ran the car so it's essentially brand new. - Sold
New Edelbrock 3-point strut tower bar, black - Sold
Used Lingenfelter cold air intake. Cleaned and re-spayed the filter - Sold
Used Hypertech Air Foil - $30 Shipped
I also have stock engine parts like cam, crankshaft, and intake manifold if anyone is interested.
New Edelbrock 3-point strut tower bar, black - Sold
Used Lingenfelter cold air intake. Cleaned and re-spayed the filter - Sold
Used Hypertech Air Foil - $30 Shipped
I also have stock engine parts like cam, crankshaft, and intake manifold if anyone is interested.
Last edited by Ralls; Mar 8, 2008 at 01:13 AM.
Thread Starter
Joined: Oct 2005
Posts: 1,687
Likes: 0
From: Fairfax, Virginia
Also considering on selling my brand new Canton fabbed valve covers - Sold
They look like this: http://www.cantonracingproducts.com/...vers/65206.jpg
I hate to sell any of this stuff, but I need the money to finish my build.
They look like this: http://www.cantonracingproducts.com/...vers/65206.jpg
I hate to sell any of this stuff, but I need the money to finish my build.
Last edited by Ralls; Jan 23, 2008 at 08:10 PM.
Thread Starter
Joined: Oct 2005
Posts: 1,687
Likes: 0
From: Fairfax, Virginia
